Catálogos >
VOLTECO >
REPOSOL

REPOSOL
1 / 2Páginas

Excertos do catálogo

PRODUCTS FOR CONSOLIDATION AND STRUCTURAL BONDING REPOSOL PRODUCT DESCRIPTION Two-component fluid epoxy resin to repair wooden and concrete structures (with added sawdust, sand, ...), as well as for various types of anchorings. It is also suited as a dust-proof, water-repellent reinforced concrete filler. PRODUCT APPLICATION • To anchor metal connectors on wood, concrete and masonry • To partially restore structures made of wood or concrete (added with fillers such as sawdust and sand) • Filler for concrete or with dust-proof function for cement-based surfaces (diluted with water) • Surface protection and surface strength enhancer for cement-based surfaces (diluted with alcohol) • Simple application • Versatility • High performance Preparing the surface The surface must be free of dust and grease and as dry as possible. Preparing the mixture Pour the two components in a ratio of A/B = 1/0.6 into a container and mix at low speed until smooth. Structure reconstruction When components A+B have been mixed together, for wood reconstruction add the required amount of dry sawdust and mix thoroughly, for concrete reconstruction add sand and mix in the same way (see mixing ratio). Impregnation of concrete or surface protection of cement-based substrates When components A+B have been mixed together, for concrete impregnation add the required amount of water and mix thoroughly, for surface protection add alcohol and mix in the same way (see mixing ratio). Anchors Pour the resin mixture into the previously shaped hole and then insert the metal connector. Structure reconstruction Pour the mixture with fillers into the formwork previously set up and treated adequately to prevent adhesion of the resin. The mixture can be applied directly on the structure with no formwork if a little filler material is to be applied.

Abrir o catálogo na página 1

PRODUCTS FOR CONSOLIDATION AND STRUCTURAL BONDING REPOSOL Impregnation of concrete or surface protection of cement-based substrates Several coats of the emulsion are applied with a roller or brush until it is no longer absorbed. PACKAGING AND STORAGE 8 kg packages (component A: 5 kg bucket - component B: 3 kg bucket). WARNINGS - IMPORTANT NOTES The epoxy resin is affected by temperature during the hardening phase, therefore, the application times can vary from 15 minutes to a few hours. Maximum working temperature 70°C. If diluted with alcohol, while it is being handled, keep away from open...

Abrir o catálogo na página 2