Catálogos >
VOLTECO >
PROCLEAN

PROCLEAN
1 / 2Páginas

Excertos do catálogo

PROCLEAN PRODUCT DESCRIPTION PROCLEAN is a water-dispersed additive-based treatment with a disinfectant function, capable of neutralizing and protecting outdoor and indoor surfaces contaminated with mould, fungi and algae. PRODUCT APPLICATION Preparation of mineral or synthetic surfaces before applying CP0, CP1, CP2, PAINT AIR and PAINT PROTECTION, X-LIME and X RAPID or levelling products and paints in general, to both prevent and remove deterioration caused by mould and algae. Particularly suitable for: • North-facing facades • Outdoor or indoor wall surfaces with cement-based or lime plaster, lightweight plaster, both new and old • Surfaces with synthetic finishes, quartz coatings or plastic paints • Surfaces damaged by condensation, such as bathrooms, kitchens, cellars and under stairs • Screeds or flooring affected by fungi, before waterproofing • Concrete surfaces • It disinfects contaminated surfaces thanks to the capacity to abate fungal micro-organisms and inhibit their growth or proliferation • It does not require dilution with water • It does not require washing after treatment • Not film-forming • Can be applied in closed and poorly ventilated environments as it is solvent-free Preparing the surfaces High-pressure clean the surfaces affected by fungi, also eliminating any traces of oil or grease, and wait for them to dry. Seal any cracks and repair damaged parts. The surfaces to be treated or any patches treated with repair mortars must complete the curing process, perfectly clean, cohesive and dry. Preparing the product PROCLEAN is ready to use, does not require dilution with water. Application Mix the product before use and apply it evenly, until it is no longer absorbed, in a single coating, using a brush, roller or spray gun. PROCLEAN does not require any further washing treatments for removal, as it is compatible with Volteco preparation and finishing products.

Abrir o catálogo na página 1

PROCLEAN For indoor application where it has not been possible to preventively pressure-wash to remove fungi deposits, wait for the first coat of PROCLEAN to dry, remove it with forceful brushing and then apply another coat of PROCLEAN. Overapplication Wait 2-3 hours before proceeding with applying PROFIX or any other coating on top of it. 0.15 l/m² consumption can vary depending on the porosity and absorbency of the surface. 5 l or 20 l tanks. The product must be stored in a dry place without being exposed to frost and heat (maximum temperature: 40°C) or direct exposure to the sun before...

Abrir o catálogo na página 2