Catálogos >
PROFILITEC >
Jointec GAD

Jointec GAD
1 / 1Páginas

Excertos do catálogo

Aluminium body structural expansion joint with synthetic rubber insert. Designed to bear structural movements of large sized buildings or compounds of buildings. To be installed on pre-existing surfaces, also vertically, over the spaces existing between two semi-detached parts of a building of smaller entity .They can connect and close these interspaces adjusting themselves up-wards, downwards and even transversely, according to the shrinkage-settlement movements of the whole building, either cyclic or permanent. See relevant indications on page 263. L1 Illustrated scale dimension 1:2 (GAD 700 AN) INSTALLATION: • Fasten the lateral flanges by utilizing: a) screws and dowels (1 every 18 cm proceeding parallel along the two sides). b) with a Bi-component epoxy adhesive glue. JOINTEC GAD* AN Aluminium gap width 75-105 mm Extruded aluminium profile. Good resistance to chemical agents and mechanical impacts over time. H=mm Material: Aluminium extruded Finish: Natural (AN) expansion joints joint cover - floor

Abrir o catálogo na página 1