Catálogos >
Bticino >
LINEA 100

LINEA 100
1 / 2Páginas

Excertos do catálogo

2 WIRE Video Door Entry system LINEA 100 Digital call pushbutton panel Front view 2 WIRE AUDIO digital call pushbutton panel for wall mounted installation. The device consists in a pushbutton panel with 16 keys and a digital display for the display of the operating status. Through the recognition of previously saved numerical (SCS addresses) or alphanumerical codes (logic addresses), it can be used to call handsets, and to give residents the possibility of opening the door lock using a dedicated numerical code. The pushbutton panel can manage up to 4000 handset addresses (from 0 to 3999), and the direct call to the 2 WIRE switchboard. It has an internal contact (C – NO – NC) for connection of an electrical door lock, or an external actuator (for the powering of the electrical door lock use an auxiliary transformer, item 336842). Connection (PL) for connecting a local door lock release pushbutton. System power supply cuts do NOT cause the loss of memory data. Technical data Power supply from SCS BUS: Stand-by absorption: Max. operating absorption: Contact load (C - NO - NC): Operating temperature: Protection index: Protection index against mechanical impact: 2. Keypad lighting LED 3. Microphone 4. Alphanumeric keypad OK key, code confirmation key, door lock release key, call to the switchboard 7. 2 WIRE SCS/BUS connection clamps (BUS) 8. Clamps (1 - 2) for the connection of the additional power supply 9. Clamps (PL) for the connection of a local door lock release pushbutton 10. Contact clamps (C - NO - NC), for the connection of the door lock /external actuator 11. Microphone volume adjustment 12. Loudspeaker volume adjustment 13. Configurator socket A 14. Jumper J2- connected = enabled tones disconnected = disabled tones 15. Jumper J1- connected = additional power supply disabled disconnected = additional power supply enabled

Abrir o catálogo na página 1

LINEA 100 Digital call pushbutton panel The device MUST be configured with physical configurator connection to the appropriate sockets as follows: P - entrance panel number J2 The configurator in socket P of the device assigns to this a recognition number inside the system. The numbering of the entrance panels must always start from P = 0 (unless the system includes a 2 WIRE switchboard). The entrance panel configured with P = 0 (no configurator connected) must be a standard (or main) entrance panel. N - NOT USED T - door lock relay timing P Configurator number * Operation as pushbutton for...

Abrir o catálogo na página 2