DALI-BOX Interface v2 Interface for one DALI bus with up to 64 devices and 64 lighting groups ZDIDLIV2 TECHNICAL DOCUMENTATION FEATURES • Possibility of controlling up to 64 DALI ballasts and up to 64 lighting groups (groups from number 17 to number 64 are only for one DALI ballast) • Compatibility with emergency lighting and colour ballasts (DT8). • Scene sending and saving • Error detection and monitoring • Burn-in, Stand-by and Auto-off functions • Manual control through buttons and status indication through display • 1.54” display (128 x 64 pixels) for settings and notifications • External power supply of 110-240V 50/60Hz • Total data saving on KNX bus failure • Integrated KNX BCU • Size 67 x 90 x 79mm (4.5 DIN units) • DIN rail mounting according to IEC 60715 TH35, with fixing clamp • DALI Standard certified • Conformity with the CE directives (CE-mark on the right side) 1. DALI bus channel 2. Control buttons 3. Display 4. Power supply indicator LED 5. External power supply 6. Programming LED 7. Programming button 8. KNX connector 9. Fixing clamp Programming button: short press to set programming mode. If this button is held while plugging the device into the KNX bus, it enters the safe mode. Programming LED: programming mode indicator (red). When the device enters the safe mode, it blinks (red) every half second. During the start-up (reset or after KNX bus failure) and if the device is not in safe mode, it emits a red flash. 1 Maximum consumption in the worst-case scenario (KNX Fan-In model). © Zennio Avance y Tecnologla S.L. Further information www.zennio.com

EXTERNAL POWER SUPPLY SPECIFICATIONS AND CONNECTIONS WIRING DIAGRAMS A NOTE: In case of ballast replacement, please, pay attention to the steps defined in the manual. /j\ SAFETY INSTRUCTIONS AND ADDITIONAL NOTES A NOTE: In case of a DALI channel short circuit, the device will monitor the DALI channel in order to switch on the output at full current just as the short circuit is removed. Installation should only be performed by qualified professionals according to the laws and regulations applicable in each country. Do not connect the mains voltage nor any other external voltage to any point of...