•*Zennio Full Color Capacitive Touch Panel with 7'' Display ZVIZ70V2 TECHNICAL DOCUMENTATION FEATURES 7" full-color capacitive touch panel (1280x800 pixels) 1 16 million color LCD display Proximity and luminosity sensor Loudspeakers for acoustic notifications Thermostat Optional features according to the license type (sold separately): Remote control from app, video intercom and internal calls 4 analog/digital inputs Built-in temperature probe External 24-29VDC power supply Micro-USB connection for firmware update and additional functional Ethernet connection Total data saving on KNX bus failure Integrated KNX BCU Dimensions 189 x 137 x 37mm (it protrudes 11.8mm from the wall) Flush mount on double European and double British standard mounting box Conformity with the CE directives (CE-mark on the back side) 1. Touch screen 2. Luminosity and proximity sensor 3. Inputs connector 4. Power input 5. Programming button 6. Programming LED 7. KNX connector 8. Micro-USB connector 9. Ethernet connector 10. Temperature probe P rogramming button: short press to set programming mode. If this button is held while plugging the device into the KNX bus, it enters the safe mode. Programming LED: programming mode indicator (red). When the device enters the safe mode, it blinks (red) every half second. During the start-up (reset or after KNX bus failure) and if the device is not in safe mode, it emits a red flash. 1 Maximum consumption in the worst-case scenario (KNX Fan-In model). © Zennio Avance y Tecnologla S.L. Further information www.zennio.com

INPUTS CONNECTION Any combination of the following accessories is allowed in the inputs: Temperature Probe** Motion Sensor Switch/Sensor/ Push button * In case of using ZN1IO-DETEC-P sensor, its micro switch number 2 must be in Type B position. ** Zennio temperature probe or any NTC with known resistance values at three points in the range [-55, 150°C]. INSTALLATION INSTRUCTIONS 1. Place the metallic plate into a standard double back box with screws, checking that it is centred. 2. Connect the KNX bus to the Z70, as well as the external power supply and the A/D input terminals. 3. Once the power...