Engineered Jointing Thermal Conductivity Extensive Range High Performance PIR Floor Insulation Board High Thermal Performance Certified Thermal Conductivity Robust Engineered Jointing BRE Green Guide A+ Rated More than insulation

The route to Zero Carbon fabric performance will lead to innovation in building design and materials used. Xtratherm have developed Hyfloor T&G floor insulation as the answer to meeting the higher U-value performances required for floors – in a practical and robust manner. Confidence you can stand over Hyfloor Under Floor Insulation has superior thickness to performance ratio allowing the lower targets required under the new Building Regulations to be achieved with minimum thicknesses. High Compressive Strength Achieves Zero Carbon Standards Thicknesses to tie in with brick coursing T&G jointing...

Hyfloor Under Floor Insulation XT/HYF Hyfloor is an engineered T&G jointed high performance Under Floor Insulation consisting of a high performance rigid Polyisocyanurate (PIR) core with branded gas tight facings both sides, it has a thermal conductivity of 0.022W/mK. Installation Guidelines Standards Xtratherm Thin-R range is manufactured to EN ISO 13165 under Quality Systems approved to EN ISO 9001:2008 Quality Management, EN ISO 14001:2004 Environmental Management and BS OHSAS 18001 Health and Safety Management System. Storage Xtratherm Thin-R should be stored off the ground, on a clean, flat...

Xtratherm Technical Services All the members of our technical team are individually BBA accredited to help you reach your low energy goals. BBA qualified in U-value calculation, condensation risk and also Thermal Bridging 3D analysis backed by BRE accreditation – when you call Xtratherm, you can be assured you’re speaking to a qualified person. Walls: Insulation for Partial Fill Cavity Wall Walls: Full Fill Built-in Insulation for Traditional Build Walls: Insulation with enhanced performance for Partial Fill Cavity Walls Floors: Insulation for Ground Supported and Suspended Floors Walls: Insulation...