Electric Dryer PRODUCT MODEL NUMBERS WED9050X, WED9051Y, WED9150W, WED9151X, WED9151Y, WED9250W, WED9270X, WED9371Y DRYER DIMENSIONS Front view: Door open view: Side view: 27" (686 mm) 29" (736 mm) 481/8" (1238 mm) 471/8" (1197 mm) Left or right side exhaust 35 3/8" (899 mm) 3 1/2" (89 mm) 1" (25 mm) 1 5/8" (41 mm) 6 7/8" (174 mm) Back view: Closet Installation (stacked washer and dryer): 61/4" (159 mm) Closet installation (dryer only): 6" (152 mm) 3" (76 mm) Electric 71" (1803 mm) 3" (76 mm) 34" recommended (864 mm) 48 in. (310 cm2) 2 18" min. (457 mm) 48 in.2 (310 cm2) 281/8" (715 mm) 51/2" (140 mm) 31/2" (89 mm) 1" (25 mm) 14" (358 mm) 3" (76 mm) 24 in.2 (155 cm2) 1" (25 mm) 1" (25 mm) Cabinet installation (dryer only): NOTE: Most installations require a minimum 5" (102 mm) clearance behind the dryer for the exhaust vent with elbow. See “Venting Requirements”. 3" (76 mm) 4" (102 mm) 24 in.2 (155 cm2) 1" (25 mm) Spacing for recessed area or closet installation All dimensions show recommended spacing allowed, with tested spacing of 0" (0 mm) clearance on sides and rear. 7" (178 mm) ■■ Additional spacing should be considered for ease of installation and servicing. 18" (460 mm) Custom under counter installation (dryer only): ■■ Additional spacing should be considered on all sides of the dryer to reduce noise transfer. 39" min. (990 mm) 1" (25 mm) ■■ For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilitation openings are acceptable. 4" (102 mm) ■■ Companion appliance spacing should also be considered. 1" (25 mm) NOTE: Some models not recommended for undercounter installation. ■■ Additional clearances might be required for wall, door, and floor moldings. 1" (25 mm) 1" (25 mm) ■■ No other fuel-burning appliance may be installed in the same closet as the dryer. W10443041B 05/2012 W10443041B v1-D-WH.indd 1 5/7/12 2:02 PM

INSTALLATION REQUIREMENTS ELECTRICAL REQUIREMENTS To supply the required 3 or 4 wire, single phase, 120/240 volt, 60 Hz, AC only electrical supply (or 3 or 4 wire, 120/208 volt electrical supply, if specified on the serial/rating plate) on a separate 30-amp circuit, fused on both sides of the line. Connect to an individual branch circuit. Do not have a fuse in the neutral or grounding circuit WATER (STEAM MODELS ONLY) REQUIREMENTS The dryer must be connected to the cold water faucet using new inlet hoses. Do not use old hoses. Do not overtighten. Damage to the coupling can result. VENTING REQUIREMENTS...