LIQUID-APPLIED WATERPROOFING ELASTIC SYSTEMS PRODUCT DESCRIPTION AQUASCUD 500 is a silane modified polymer-based waterproof coating paste, solvent-free, ready for use and cold-applicable. It hardens by reacting with the ambient humidity creating an elastic elastomer membrane with excellent mechanical performance. The coating is semi-glossy light grey with the possibility of obtaining a smooth or non-slip finish if combined with the specific GRIPPER filler. PRODUCT APPLICATION • Walk-on finish of Volteco waterproofing, in combination with AQUASCUD BASIC membrane on screed and flooring in general such as balconies, terraces, pedestrian walkways, sidewalks, stairways etc... ADVANTAGES • Excellent walkability with possibility of non-slip finish • High elasticity and capacity to bridge cracks in the surface • Total adhesion to base • Easy and fast application, self-levelling • Also applicable to damp substrates • Quick curing, regardless of rain, in 4 hours, also in conditions of high ambient humidity • Excellent resistance to UV radiation • Possibility of using it as a finish in place of tiles PREPARATION AND APPLICATION Preparing the surfaces The surface must have a minimum compressive strength of 15 N/mm2 and at least 28 days of curing must have elapsed. Thoroughly clean the surfaces by brushing or low-pressure washing to remove all traces of dust, dirt, salt deposits, efflorescence and loose parts. Restore missing parts or seal any cracks by applying a suitable cement-based levelling compound. Recommendations prior to installation If you wish to obtain a walk-on coating with total waterproof performance it is necessary to prepare the following details and set-ups: • EXPANSION JOINTS AND SIGNIFICANT CRACKS Any expansion joints and significant cracks on the surface must be covered with GARVO joint cover strip (see related technical data sheet) • CORNERS AND CONNECTIONS Set the connections up with drains using the relative DRAIN MANIFOLD

LIQUID-APPLIED WATERPROOFING ELASTIC SYSTEMS Connect all the wall/floor corners with the AQUASCUD JOIN BT staff bead (see relative technical data sheet). Installation surface waterproofing Use a specific notched trowel (3.5 mm notches) to apply a waterproofing layer using a product from the AQUASCUD or PLASTIVO range (see relative technical data sheets) then fresh-spreading the AQUASCUD BASIC membrane onto it, avoiding overlaps between adjacent sheets and taking care to join the edges which must have a gap of no more than 5 mm. Proceed in sections by laying AQUASCUD BASIC immediately on the freshly...

LIQUID-APPLIED WATERPROOFING ELASTIC SYSTEMS Elongation at breaking point UNI EN ISO 527-3 > 80% Performance requirements Dry: 66 PTV Wet: 47 PTV * with GRIPPER SAFETY This is a non-toxic alkaline product. It is recommended to use a mask and gloves while working. Accidental contact with eyes, rinse thoroughly with water and seek medical advice. COPYRIGHT © Copyright Volteco S.p.A. - All rights reserved. Information, images and text found in this document are exclusive property of Volteco S.p.A. They may change anytime without prior notice. Updated versions of this and other documentation...