Wood Penetration Oil TECHNICAL CHARASTERISTICS STORAGE Containers must be kept closed in a cool, dry, well ventilated area protected from direct sunlight at temperatures between 5°C - 38°C. SAFETY ADVICE Read label before use. For further instructions -precautions see Material Safety Data Sheet. Mixture of modified natural oils combined with wax. It can be used to refresh and preserve wooden surfaces like teak, oregon, rosewood, mahogany etc. as well as for all bare woods. It is suitable for interior and exterior use. It penetrates deeply through the wood pores preventing the penetration of water and enhances its natural beauty. Refresh, preserve and protect the wood from the strong sunlight and humidity. • Penetration oil from mixture of modified natural oils enriched with wax • Refresh, preserves and protect the wood from the strong sunlight and humidity COLOURS Available colourless. PACKAGING SPREADING RATE 14 - 16 m2/L per coat on previously prepared surfaces. VOC (Volatile Organic Compounds) CONTENT EU maximum VOC content limit values (Directive 2004/42/CE) for this product (category A/h "Binding primers", Type SB): 750 g/L. This product contains maximum 450 g/L VOCs (ready for use product). SURFACE PREPARATION Surfaces should be smooth, clean, dry, free from grease, resins or old varnishes. APPLICATION Stir well before use. Apply one coat by brush or piece of cloth without dilution. Wipe excess material after 5 minutes with a dry cloth. Apply a second coat for tough wood or when wood is exposed to adverse weather conditions. Do not apply at temperatures below 5°C, above 35°C and/or relative humidity above 80%. It is touch dry after 2-3 hours and can be recoated after 2 days. Drying time depends on weather conditions (humidity and temperature). Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and then with soapy water or detergent.