Lussolac TECHNICAL CHARASTERISTICS SPREADING RATE 12 - 16 m2/L per coat on properly prepared surfaces. VOC (Volatile Organic Compounds) CONTENT EU maximum VOC content limit values (Directive 2004/42/CE) for this product (category A/e "Interior/exterior trim varnishes and woodstains, including opaque woodstains" Type SB): 400 g/L. This product contains maximum 399 g/L VOCs (ready for use product). SURFACE PREPARATION Surfaces should be smooth, clean and dry, free from grease or resins and abrased. On new wooden surfaces apply preservative Diaxyl Decor. APPLICATION Stir well before use. Apply one or two coats by roller or brush diluted up to 5% with Brush Solvent T 300 or airless spray gun diluted up to 5% with Spray Gun Solvent T 350. Do not apply at temperatures below 50C, above 350C and/or relative humidity above 80%. It is touch dry after 3-4 hours and can be recoated after 20-24 hours. Drying time depends on weather conditions (humidity and temperature). Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 and then with soapy water or detergent. Use Spray Gun Solvent T 350 to clean spray guns.