and then with soapy water or detergent. Use Spray Gun Solvent T 350 to clean spray guns. Solvent based silicon alkyd tough enamel with excellent durability, suitable for exterior use on metallic. It forms a very hard film, without the addition of hardener, retaining its gloss and shade unchanged, even if exposed to adverse weather conditions or washed. It offers great hiding power as well as excellent working and levelling properties. It can be recoated with any alkyd or acrylic topcoat. • Silicon alkyd tough enamel • Top hardness • Ultra high durability COLOURS STORAGE Containers must be kept closed in a cool, dry, well ventilated area protected from direct sunlight at temperatures between 5°C - 38°C. SAFETY ADVICE Read label before use. For further instructions -precautions see Material Safety Data Sheet. SPREADING RATE 13 - 15 m2/L per coat on properly prepared surfaces. VOC (Volatile Organic Compounds) CONTENT EU maximum VOC content limit values (Directive 2004/42/CE) for this product (category A/i "One-pack performance coatings", Type SB): 500 g/L. This product contains maximum 495 g/L VOCs (ready for use product). SURFACE PREPARATION Surfaces should be cleaned with Brush Solvent T 300, be smooth and dry, free from dust, grease or rust and sanded. Metallic surfaces should be coated with an anticorrosive primer (Anti-Rust Primer, Minio New Type or Metal Primer). Glossy metallic surfaces (aluminum, galvanized steel etc) should be first coated with Primer for Glossy Surfaces or Wash Primer. APPLICATION Stir well before use. Apply two coats by roller or brush diluted up to 5% with Brush Solvent T 300 or airless spray gun diluted up to 5% with Spray Gun Solvent T 350. Do not apply at temperatures below 5°C, above 35°C and/or relative humidity above 80%. It is touch dry after 2-3 hours and can be recoated after 16-18 hours. Drying time depends on weather conditions (humidity and temperature). Allow at least 30 days before cleaning and washing newly painted surfaces with Heavy Metal Silicon. Clean rollers, brushes, floor stains, etc. with Brush Solvent T 300 T.®. 139 HP£P09 ^nponiipyoc T.K. 193 00 P.O. Box 139 Imeros Topos, Aspropyrgos GR 193 00 T. + 30 210 5589 500, F. + 30 210 4835 007, www.vitex.gr