V210-Rhodos
V210-Rhodos
- Width: The awning width should be measured to ensure it is as wide as possible while staying 20 cm inside the outer corners. The minimum width is 1655 mm, and the maximum is 6000 mm.
- Projection: This is the distance from the wall to the front bar, affecting the shading effect. The document provides a table with minimal width requirements for different projections.
- Control Side: The control side is determined from the outside perspective. The document notes the importance of understanding the wiring direction for electrical controls.
- Obstacles: Consider rain pipes and other potential obstructions when planning the installation.
- Height Requirements: A minimum installation height of 2.40 meters is necessary for optimal use. The pitch of the awning can be adjusted.
- Wall Support: Ensure there are at least five rows of stones above the wall supports to distribute pressure effectively. Wall strips may be needed if the wall is weak.
- Patio Doors and Windows: Maintain at least 30 cm between the window frame and the underside of the awning.
- Measuring the product yourself is at your own risk. It is recommended to use the measuring service of a Verano® dealer if unsure.
- Avoid installation points in the soldier course, as these are often half stones.
Catalog excerpts
Measuring instruction awning V210 Rhodos A good preparation! Keep the following attention points into account when ordering an awning. 1. Determine the desired width. An awning ensures that sunlight will not enter the house, but also provides a shady terrace in your garden. It is therefore advisable to measure the awning as wide as possible, but always stay 20 cm inside the outer corners. 2. Choose the desired projection. Projection is the maximum distance between the wall and the front bar. The bigger the projection, the bigger the effect of the sun awning. For more information, please see the specifications on page 3. 3. Choose the control side. Determine the control side. The control side is always seen from the outside. Subject to misprints, errors and technical modifications. Attention! If the wire of the electrical control (outside) goes in on the left side, the wire is, seen from the inside, on the right side and vice versa.
Open the catalog to page 1
Measuring instruction awning V210 Rhodos Extra attention points! Watch for any obstacles! Take rain pipes and other obstacles that can obstruct mounting on the wall into account. Check the installation height Check if you have enough installation height on the façade to install the awning. Above the wall supports (installation support) need to be five rows of stones to prevent the amount of pressure on the façade. Especially with an extension, this can not be the case. It is advisable to drill the top installation hole in the middle of the fifth stone from the top. Attention! Make sure that there...
Open the catalog to page 2
Measuring instruction awning V210 Rhodos Front view left wall support Section awning Minimal width (W) per fabric projection Minimal awning width (W) [mm] 1655 2235 2740 3320 Subject to misprints, errors and technical modifications.
Open the catalog to page 3All Verano catalogs and technical brochures
Windscreen22 Pages
Glass wall8 Pages
Wooden canopy awning8 Pages
