Technical Sheet Via dell'lndustria, 80 - 60020 POLVERIGI (AN) ITALY E-mail: [email protected] TECHNICAL DATA DRYING TIME: APPLICATION CYCLE: A water-based paint for interiors, characterized by luminescent reflections and three-dimensional colour effects, evoking the motion of sea waves. water based paint for indoor use specific weight: aesthetic effect: 12-14 m2/LT a coating (it may vary according to the roughness, porosity and surface absorption and to the method of application ) colours from the catalogue A water-based paint for interiors, characterized by luminescent reflections and three-dimensional colour effects, evoking the motion of sea waves. Thanks to its crystal particles, it is able to create environments that are unique among their kind. To obtain the typical nuances characterizing MAVERICKS, both containers must be supplemented with the two L50 cans each containing a different Remove old non-adhering and peeling paint then wash using a suitable soap product. Subsequently and where necessary, smooth the surface once it dries using sandpaper then apply a suitable fixative. Lastly, apply NAUTILUS and system: brush, Use a roller or brush to apply one coat of NAUTILUS to cover new, intact and smooth surfaces, preferably using criss-cross strokes. Only after 8 hours at 20°C apply MAVERICKS using the appropriate Double Brush PV 102 consisting of 2 paired brushes, each of which can be wetted with a different colour without inverting them. Apply MAVERICKS gradually over a small surface of roughly 1 - 2 m2 (at a time), if the temperature ranges between 15°C and 20°C; in case of lower temperatures, a larger surface can be covered (one portion at a time). The application technique consists in applying a small amount of product with alternating brush strokes in all directions. While the paint is still partly wet, brush over using Brush PV 103 without paint: apply criss-cross strokes and spread the crystal particles of MAVERICKS while applying pressure. This will create the impression of sea waves with broad and jagged - but not round - waves. page 1 of 2 VALPAINT TUNISIESA. 2° Stabilimento VALPAINT MAROC S.A.R.L VALPAINT ALGERIE S.A.R. ZonelnduslridbZaghouan Rue Des Enlrepreneurs, 43 Rue Kaied El Achlar, 7 Route de Sefif, 9 L. VALPAINT ESPANA S.L VALPAIN1 DESIGN D.O.O. Altro PuntoVendita: Atro Punto Vendita: Calle Magdalenes, 25 3° Diemala Bijedica, 281 V Proleterske Brigade, 255 1C Solidum-Skorpikova, 11 08002 BARCELONA-ESPANA 71000 SARAJEVO - BiH 81000PODGORICA- MONTENEGRO 10090 ZAGREB - CROATIA E-mail: [email protected] E-mail: [email protected] E-mail: [email protected] E-mail: [email protected]

Via dell'lndustria, 80 - 60020 POLVERIGI (AN) ITALY E-mail: [email protected] As a final touch, we recommend passing over the surface with delicate criss- cross brush strokes to remove any marks left by the brush. Application temperature: between +5°C and +25°C. Storage: close the tin tightly after use and store at a temperature between Stability: approximately 2 years, if well sealed and never opened Mix well before use Wash the tools soon after use with water and soap. Technical Sheet n° SC 00250 issued by the Control Responsible Department VALPAINT TUNEIESA 2° Stabilimento VALPAINT MAROC S.A.R.L...