www.valpaint.it • www.valpaintjungle.it Via dell'lndustria, 80 ■ 60020 POLVERIGI (AN) ITALY E-mail: [email protected] Technical Sheet TECHNICAL DATA DRYING TIME: antique effects paints water based paint for indoor use specific weight: aesthetic effect: roughness, porosity and surface absorption and matt, satined and metallic colours from the catalogue Versatile and visually striking water-based paint for indoor use. This product may be used to create many different decorative effects from classic to floral; even t he most sought-after metallic effect can be achieved. When hardening is complete, a breathable film develops which offers goods resistance to knocks and normal abrasion It is washable with water and ordinary detergents 15 days after application. Old walls. Remove old badly-adhering or peeling paint and wash using a suitable soap product. Use a suitable filler to repair the surface where necessary. When the filler is dry, after approximately 4 hours at 20°C, apply a coat of Primart 600 diluted 50% with water as a fixative. After approximately 4 hours at 20°C, apply a second coat of Primart 600 diluted 15 - 20% with water. If, however, the surfaces are not chalking or peeling, apply a coat of Primart 600 diluted 15-20% with water once the filler has dried. New walls. Use a suitable filler to repair the surface where necessary. When the filler is dry, after approximately 4 hours at 20°C, sand the surface then apply a coat of Primart 600 diluted 15 - 20% with water. After 4 hours at 20°C, proceed with the application of ARTECO' 7 catalization relation: brush, plastic spatula E-mail: [email protected] E-mail: [email protected] Zone Industrielle Zaghouan E-mail: [email protected]

- www.valpaint.it • www.valpaintjungle.it - APPLICATION CYCLE: To create the colours and effects displayed in the catalogue, carefully mix the ARTECO' 7 with the exact amount of COLORT colouring paste required. Alternatively, the VALCLONE paint-mixing system may be used to achieve the desired colour. To obtain the metallic finishes, it will then be necessary to add the product L50 (supplied in a 0,100 or 500 ML pack), which is available To vary the colour of the particles in ARTECO' 7, add the product P40 (supplied in a 280 ML pack), available in 10 different colours. The decorative effects that...