Electric heating for industry EP
20Pages

Electric heating for industry and property Electric boilers, 26-750 kW (10 MW) Electric cartridges, 13-15 kW Immersion heaters, 1.5-9 kW www.varmebaronen.com ELECTRIC BOILERS INDUSTRY & PROPERTY

Facts about Värmebaronen  Värmebaronen began operations in 1975 and Our development depart­ ment works constantly Our products provide heating for satisfied is now one of the leading manufac­ to adapt our products to market turers of heating systems in Sweden. domestic market and in the rest Our products are known for their high quality and long service life. An extensive product range makes Our product range meets the maximum require­ it possible to create carefully con­ ments for technical reliability, eco­ sidered, reliable heating systems. friendliness and cost efficiency. Värmebaronen...

Varmebaronen has the widest range of electric heating products on the market. Everything from a 1.5 kW immersion heater to the largest electric boiler with an output of 750 kW. Not so long ago, electric heating was often installed as the primary heat source in houses and other properties. It is now often used as additional heating to one or more heat pumps, for example. The cost of installing an electric boiler is low and the job is fast and easy. When it is cold outside and the heat pump does not manage to maintain the heat, the topup heat from the electric boiler is invaluable. Immersion...

VISBY Corvette Photo: Kockums Celsius corvettes of type VISBY are fitted with stainless, modified EP 42 that have to cope with 6 G, among other things. Additional heating, industry & process TELESCOPE, CHILE CUSTOMER: ESO ANTI-ICING CUSTOMER: SWEDISH NATIONAL RAILWAYS The world’s largest telescope, VLT, was put into The heated anti-icing fluid is sprayed on the trains’ use in Chile in March 1999. The customer chose bogies and other selected areas to remove ice and Värmebaronen’s EP electric boilers for the telescope’s heating requirements. WAVE POOL CUSTOMER: SKARA SOMMARLAND STAINLESS...

Bäckaskog castle in north-eastern Skåne is perhaps best known as King Karl XV’s sum­ mer palace. ADDITIONAL HEATING CUSTOMER: BÄCKASKOG GRAIN DRYING CUSTOMER: KLF The main building is heated by three NIBE Fighter Drying plant. Kristianstadsortens Lagerhusförening 1320 of 40 kW each. A Värmebaronen EP 52 electric uses 6 x EP 750 kW, 690 V to dry grain during the boiler provides topup heating when it is needed. harvesting season. ADDITIONAL HEATING CUSTOMER: EG-BYGG ADDITIONAL HEATING CUSTOMER: FORMPLAST Formplast in Broby uses four NIBE Fighter 1330 ground- Block of flats. 12 flats. Heating...

Save more than SEK 20,000 by making the right choice Factory-fitted safety equipment, fully connected internally.

We have unique expertise in waterborne electric heating. Approved for installation without a steam-collecting vessel Thanks to factory-fitted factory-fitted safety equipment factory-fitted, it does not require any safety equipment, special inspection either. It meets the requirements when it leaves offer electric boilers approved for periodic moni­oring of a boiler t for installation without a steam- system, checked by a third party. collecting vessel. The safety equipment, combined All electric boilers tolerate zero with the uniquely simple installation, flow and can be installed without...

Exploded view. See opposite page for explanation. EP advantages THE EP SERIES, boilers Smart temperature control adjusts Alarms are indicated on the front the power supplied to increase the panel. The boilers also have a service life of the boiler’s contactors. connection for an external buzzer systems and industrial processes. Output from 31 to 750 kW. Interconnectable. alarm. For safety reason, the EP series copes with flows down to zero, i.e. When used with, for example, The boilers’ output is divided into 7, the boilers do not need to be fitted a plate heat exchanger, the boilers 15 or...

The boilers can be supplied with factory-fitted safety equipment for installation without emergency protection, a steam-collecting vessel, level sensor, etc. Accessory. The all-pole main switch cuts all incoming power if a fault is detected by the boiler’s controller. This is important to maintain high safety. All pipe connections are threaded or flanged. This results in cheaper valves and fewer pipe welds. The boiler can be disconnected more easily. Wider diameter connections result in smaller circulation pumps. The built-in float switch immediately produces an alarm if the boiler is not...

EP 31-750 kW ELECTRIC BOILERS for heating systems and industrial processes. The electric boiler series consists of twenty-four different boilers with output from 31 to 750 kW. 7, 15 or 30 power steps The boilers' output is divided into 7, 15 or 30 steps. The temperature control adapts the power supplied to heating requirements. When the boiler is used with a heat pump, it is an advantage to have many steps as the boiler can initially supply low power to act as a support heat source. In a process, it may be more suitable to have fewer steps so that the boiler immediately supplies high power....

n We heat all types of liquid medium In series or parallel The boilers can be connected together in serie up to 1,5 MW or in parallel up to 10 MW. A smart series controller is available as an accessory. This ensures that the boilers' operating time is evenly distributed between all boilers. Stainless steel immersion heaters The immersion heaters are made of stainless steel with brass heads as standard. Also available in other materials and qualities. External control (e.g. heat pump) Output can be externally blocked or controlled with a voltage or current signal. A 0-10V output signal...

Compact, high-efficiency electric boilers. The EP E series for radiator heating, additional heating or industrial processes. The EP E series is available in outputs of 26 and 42 kW. The principal features are the compact design and high reliability. The EP E series is used to heat waterborne systems, as a supplement to heat pumps or in various industrial processes. The maximum power can be limited: • EP 26 E to, for example, 22.5 kW, 18.75 kW or 15 kW. • EP 42 E to, for example, 36 kW, 30 kW or 24 kW. Stainless steel immersion heaters The immersion heaters are made of stainless steel with...