illbruckmaking it perfect. Composition PVA emulsion Description Liquid Colour White liquid, dries translucent Packaging 1 kg bottle (12 per carton) 5 kg bottle (4 per carton) 25 kg drums Technical Information Characteristic Composition Conformance Specific Gravity Viscosity (at 20°C) Open Time Maximum Bond Strength (at 20°C) Application Temperature Service Temperature Storage Shelf Life Results (Typical Values) PVA emulsion EN 204: D3, BS 4071 Creep Resistant 1.05 10,000 - 20,000 cps 5 minutes 24 hours +5°C to +25°C -30°C to +80°C Store in shaded, dry conditions between +5°C and +25°C 12 months when stored as recommended in original, unopened containers Wood Adhesive Necessary Tools • Paddle or spatula to stir adhesive, and suitable brush, roller or spray equipment to apply adhesive. Protective Equipment Use in well ventilated conditions and ensure all recommended protective equipment is worn during handling & use of this product. For full recommendation, refer to safety data sheet. Preparation • All surfaces to be bonded must be close fitting, degreased, clean, and free from dust and any other contamination. Application • Remove any skin on the surface of the adhesive and stir before use. • Apply the adhesive to one surface only using brush or roller. • Open time will be approximately 5 minutes depending on ambient conditions. • Assembly should be made as soon as convenient within the open time. • Pressing should be carried out as soon as possible after assembly whilst the adhesive is still wet. It is recommended that a press time of 14 - 20 minutes is used at 20°C. In a heated press at 70°C the minimum press time is reduced to 3-5 minutes. Pressure should be between 0.21 and 0.69 N/mm2 (30 to 100 p.s.i.). Usage / Purpose WD120 is a premium PVA adhesive sutiable for internal and external applications where resistance to water is required. It is ideal for bonding wood, decorative laminates, chipboard, blockboard, veneers and similar substrates. illbruck WD120 is suitable for use in non-stressed high humidity indoor environments and indoor our outdoor applications where intermittent contact with cold or hot water may occur. Key Benefits • Weatherproof PVA adhesive suitable for external use - meets the requirements of EN 204 (D3) • Can be used in load bearing applications - tested to BS 4071 for creep resistance • Suitable for RF curing systems, hot and cold pressing and for brush, roller or spray application • Rapid development of bond with a high final bond strength

Wood Adhesive illbruck making it perfect. Bonding Time • The following are indicative bond strength values which can be expected. All figures given are for wood to wood at approximately 14% moisture content at 20°C: • After 15 minutes press - 4.14 N/mm2 • After 60 minutes press - 6.21 N/mm2 Coverage 5.0 to 70 m2 of bonded area per kg Cleaning Tools, equipment and surplus adhesive can be removed with a damp cloth before the adhesive dries. Cured adhesive can be removed using AT200 High Strength Cleaner. Health & Safety Precautions Safety data sheet must be read and understood before use. Technical...