illbruckmaking it perfect. Description TP601 is a weather-retardant, impregnated, open-cell, polyurethane soft foam, enclosed before use in a polypropylene film with a bonding adhesive on one side for fixing. Colour Foam sealing tape - available in anthracite as standard (grey available on request). Encapsulating film - clear Adhesive release film - red Packaging Continuous spool 50 m, 100 m or 200 m depending on size Minimum installation depth = 17 mm Width of tape = 15 mm + tear off strip *To ensure 600 Pa driving rain resistance Compriband e Technical Information Property Test Method Standard Construction Material DIN 52453 Compatibility Film Thickness Driving Rain Resistance Water Vapour Permeability Application Temperature sd value <0.5 m The tape should be applied to the window frame before installation at temperatures above +10°C to ensure satisfactory adhesive tack. Service Temperature Storage Shelf Life -30°C to +90°C The polypropylene activation film must be removed within 3 months of installation otherwise this may be difficult to remove. Store rolls horizontally and in original carton between +0°C and +20°C in dry conditions and away from direct sunlight. 18 months when stored as recommended in original unopened containers. Usage / Purpose TP601 is an impregnated, precompressed foam sealing tape, encapsulated before use in a tear-off, polypropylene film with a bonding adhesive on one side for installation. The tape is intended for the external, recessed perimeter sealing of windows and doors with the same high performance characteristics as TP600. The tear-off, encapsulating film permits the post-installation expansion of the foam strip, thus ensuring an effective weather seal. Key Benefits • Factory or site application with activation within 3 months of installation • 600 Pa weather resistance • Applied before frame installation • No hazardous waste or clean up

Health & Safety Precautions No special surface preparation or primers are required but contact surfaces must be clean of dust, dirt, loose matter, grease or oils. Safety data sheet must be read and understood before use. Application • Prior to installation, TP601 is fixed to the frame by means of the self-adhesive strip. • Measure the size of the aperture, not the frame, and cut the TP601 to length, allowing an extra 10 mm per metre to form a good tight fit between the end of the tape and the wall/reveal. • It is preferable to install the horizontal edges first. Fit the tape to the top and bottom...