Description TN135 is a polyethylene double-sided foam tape that is coated on both sides with hot melt synthetic rubber resin adhesive. Packaging Thickness: 1 and 2 mm Width: 6 to 960 mm Any width within the range noted above can be cut subject to minimum order quantities. Stock size are available and our Customer Service team can supply details as well as advise on cut to order sizes, minimum order quantities and lead time. Technical Information Property Foam Type Foam Density Adhesive Format Double sided Adhesive Type Hot melt synthetic rubber Tape Colour Application Temperature Service Temperature Recommended Compression Store in shaded dry conditions between +5°C and +25°C Shelf Life 12 months when stored as recommended in original unopened packaging TN135 Economy Bonding Tape Preparation • Ensure bonding surfaces are free from irregularities and loose particles which may impair adhesion. • Dust, dirt and grease can be removed using AT115 Solvent Cleaner. Where substrates are sensitive to solvent attack, clean with warm water and allow to dry. • The substrate must always be dry before application of the tape. Application • The exposed adhesive face should be unwound gradually and carefully located onto surface of the substrate. Care must be taken to avoid compressing or stretching the tape during location - this could induce peeling forces and cause the tape to lift from the substrate. • Once the tape has been positioned then apply even pressure throughout the length using a roller, starting at the centre and moving to each end to avoid stretching. • With double sided tapes the protective release film is not removed until immediately prior to joint assembly. • Joints may be made by mitring corners or butting the tape ends tightly together. In all cases the tapes should be cleanly cut at slightly longer length than required to ensure compression of the jointing faces and formation of a tight joint. Usage / Purpose TN135 is suitable for general purpose mounting applications and conversion to pads. This product is not suitable for application where a high degree of UV exposure may occur. Designed for internal applications where bond strength is not critical such as posters, point of sale and light assembly work. • Gives instant bond with no curing time • Conve

illbruck Economy Bonding Tape making it perfect. Please Note TN135 is not designed to support heavy loads. It is not suitable for applications where a high degree of UV exposure may occur. Care should be taken to set the tape back from the exposed edge. Users are advised to conduct their own tests in order to determine the suitability of the product for the particular application. All slitting and length tolerances are to British Standards, but other tolerances are available by request. Health & Safety Precautions Safety data sheet must be read and understood before use. Technical Service tremCO...