Catalogs >
Tremco CPG Iberia & Italia - Windows & Facade >
TN132_DS_GB_2020-11-19_WEB

TN132_DS_GB_2020-11-19_WEB
2Pages

Catalog excerpts

Description TN132 is a double-sided polyethylene foam tape Packaging Thickness: 1 mm Width: 6 to 1,050 mm Any width within the range noted above can be cut subject to minimum order quantities. Stock size are available and our Customer Service team can supply details as well as advise on cut to order sizes, minimum order quantities and lead time. Technical Information Property Foam Type Foam Density Adhesive Format Double sided Adhesive Type Acrylic adhesive Tape Colour Application Temperature Service Temperature Store in shaded dry conditions between +10°C and +20°C Shelf Life 24 months when stored as recommended in original unopened packaging TN132 General Bonding Tape Preparation • Ensure bonding surfaces are free from irregularities and loose particles which may impair adhesion. • Dust, dirt and grease can be removed using AT115 Solvent Cleaner. Where substrates are sensitive to solvent attack, clean with warm water and allow to dry. • The substrate must always be dry before application of the tape. Application • The exposed adhesive face should be unwound gradually and carefully located onto surface of the substrate. Care must be taken to avoid compressing or stretching the tape during location - this could induce peeling forces and cause the tape to lift from the substrate. • Once the tape has been positioned then apply even pressure throughout the length using a roll, starting at the centre and moving to each end to avoid stretching. • With double sided tapes the protective release film is not removed until immediately prior to joint assembly. • The assembly must provide sufficient force to compress the tape by 20% of original thickness for security applications and 30% if weatherseal performance is required. Over compression should be avoided. • Joints may be made by mitring corners or butting the tape ends tightly together. In all cases the tapes should be cleanly cut at slightly longer length than required to ensure compression of the jointing faces and formation of a tight joint. Usage / Purpose TN132 is suitable for bonding to a wide range of smooth surfaces, including Glass, UPVC, aluminium, treated timber, etc. It can also be used as a primary seal in double glazed unit production. • Closed cell foam • Exce

Open the catalog to page 1

illbruck General Bonding Tape Please Note The adhesive is not UV resistant and should not be exposed to the sun, as degradation of adhesive will occur. Users are advised to conduct their own tests in order to determine the suitability of the product for the particular application. All slitting and length tolerances are to British Standards, but other tolerances are available by request. Health & Safety Precautions Safety data sheet must be read and understood before use. Technical Service Tremco CPG UK Limited has a team of experienced Technical Service Representatives who provide...

Open the catalog to page 2

TN132_DS_GB_2020-11-19_WEB 2Pages

Catalog excerpts

All Tremco CPG Iberia & Italia - Windows & Facade catalogs and technical brochures

TN132_DS_GB_2020-11-19_WEB
2Pages