Description TN106 is a double-sided EVA enhanced polyethylene foam with high shear acrylic adhesive. Packaging Thickness: 3, 4, 5 and 6 mm Width: from 6 mm to 1,230 mm in 1 mm increments. Any width within the range noted above can be cut subject to minimum order quantities. Stock size are available and our Customer Service team can supply details as well as advise on cut to order sizes, minimum order quantities and lead time. Technical Information Property Foam Type Closed cell physically cross-linked PE Foam Foam Density Adhesive Format Double sided Adhesive Type High shear acrylic Tape Colour 3mm: Black and white 4, 5 amd 6 mm: black only Application Temperature Service Temperature Recommended Compression Store in shaded dry conditions between +5°C and +20°C Shelf Life 24 months when stored as recommended in original unopened packaging Preparation • Ensure bonding surfaces are free from irregularities and loose particles which may impair adhesion. • Dust, dirt and grease can be removed using AT115 Solvent Cleaner. Where substrates are sensitive to solvent attack, clean with warm water and allow to dry. • The substrate must always be dry before application of the tape. Application • The exposed adhesive face should be unwound gradually and carefully located onto surface of the substrate. Care must be taken to avoid compressing or stretching the tape during location - this could induce peeling forces and cause the tape to lift from the substrate. • Once the tape has been positioned then apply even pressure throughout the length using a role, starting at the centre and moving to each end to avoid stretching. • With double sided tapes the protective release film is not removed until immediately prior to joint assembly. • The assembly must provide sufficient force to compress the tape by 20% of original thickness for security applications and 30% if weatherseal performance is required. Over compression should be avoided. • Joints may be made by mitring corners or butting the tape ends tightly together. In all cases the tapes should be cleanly cut at slightly longer length than required to ensure compression of the jointing faces and formation of a tight joint. TN106 Security Glazing Tape Usage / Purpose TN106 is suitable for bonding to a wide range of smooth surfaces, including glass, PVCU, aluminium, treated timber, etc. It is used as a high grade security glazing tape for bonding double glazed units into window frames. TN106 can also be used for a wide range of jointing and mounting applications. • Easy release liner • Exce

illbruck Security Glazing Tape Please Note This product is not suitable for wet glazing techniques. Please ask for application advice if required. Users are advised to conduct their own tests in order to determine the suitability of the product for the particular application. All slitting and length tolerances are to British Standards, but other tolerances are available by request. Health & Safety Precautions Safety data sheet must be read and understood before use. Technical Service tremco illbruck has a team of experienced Technical Sales Representatives who provide assistance in the selection...