Catalogs >
Tremco CPG Iberia & Italia - Windows & Facade >
TN062_DS_GB_2019-10-04_WEB

TN062_DS_GB_2019-10-04_WEB
2Pages

Catalog excerpts

illbruckmaking it perfect. Description TN062 is a polyester tape supplied in 50 m rolls, cut to required width. Packaging Width Roll Length Box Content Technical Information Property Composition Thickness Bond Strength (FINAT TM 1) Resistance to Ageing Moisture Resistance Plasticiser Resistance Compatibility Service Temperature Application Temperatu re Storage Shelf Life Results Polyester film carrier, layered on both sides with a modified acrylic adhesive 105 p (film and adhesive) ~ 30 N/25 mm width to stainless steel after 24 hours Very good Good Good Compatible with most common building materials -40°C to +160°C +15°C to +40°C Store in shaded dry conditions between +10°C and +20°C 12 months when stored as recommended in original unopened packaging Usage / Purpose TN062 is designed for bonding lightweight, flexible components with a thin bond line. Key Benefits • High shear resistant tape especially on metals Preparation • Ensure bonding surfaces are free from irregularities and loose particles which may impair adhesion. • Dust, dirt and grease can be removed using AT200. Where substrates are sensitive to solvent attack, clean with warm water and allow to dry. • The substrate must always be dry before application of the tape. • If substrate(s) require the use of a primer then they should be cleaned first, then primed, following the directions specified on the primer. Application • The exposed adhesive face should be unwound gradually and carefully located onto surface of the substrate. Care must be taken to avoid compressing or stretching the tape during location - this could induce peeling forces and cause the tape to lift from the substrate. • Once the tape has been positioned then apply even pressure throughout the length using a role, starting at the centre and moving to each end to avoid stretching. • With double sided tapes the protective release film is not removed until immediately prior to joint assembly. • Joints may be made by mitring corners or butting the tape ends tightly together. In all cases the tapes should be cleanly cut at slightly longer length than required to ensure compression of the jointing faces and formation of a tight joint.

Open the catalog to page 1

• Apply firm pressure (15 psi) to the component to consolidate the adhesive bond. • Maximum adhesion will be achieved after ~ 72 hours. • Avoid stressing the bond in the first 24 hours. Health & Safety Precautions Safety data sheet must be read and understood before use. Technical Service tremco illbruck has a team of experienced Technical Sales Representatives who provide assistance in the selection and specification of products. For more detailed information, service and advice, please call Customer Services on 01942 251400. Guarantee / Warranty tremco illbruck products are manufactured...

Open the catalog to page 2

TN062_DS_GB_2019-10-04_WEB 2Pages

Catalog excerpts

All Tremco CPG Iberia & Italia - Windows & Facade catalogs and technical brochures

TN062_DS_GB_2019-10-04_WEB
2Pages