Description TN061 is a tissue tape supplied in 50 m rolls, cut to required width. Packaging Width Roll Length Technical Information Property A double sided tissue tape with an ultra high tack, solvent acrylic adhesive Bond Strength Very good Moisture Resistance Plasticiser Resistance Compatibility with common building materials Service Temperature Application Temperature Store in shaded dry conditions between +10°C and +20°C Shelf Life 12 months when stored as recommended in original unopened packaging Preparation • Ensure bonding surfaces are free from irregularities and loose particles which may impair adhesion. • Dust, dirt and grease can be removed using AT200. Where substrates are sensitive to solvent attack, clean with warm water and allow to dry. • The substrate must always be dry before application of the tape. • If substrate(s) require the use of a primer then they should be cleaned first, then primed, following the directions specified on the primer. Application • The exposed adhesive face should be unwound gradually and carefully located onto surface of the substrate. Care must be taken to avoid compressing or stretching the tape during location - this could induce peeling forces and cause the tape to lift from the substrate. • Once the tape has been positioned then apply even pressure throughout the length using a role, starting at the centre and moving to each end to avoid stretching. • With double sided tapes the protective release film is not removed until immediately prior to joint assembly. • Joints may be made by mitring corners or butting the tape ends tightly together. In all cases the tapes should be cleanly cut at slightly longer length than required to ensure compression of the jointing faces and formation of a tight joint. • Apply firm pressure (15 psi) to the component to consolidate the adhesive bond. TN061 Double Sided Tissue Tape Usage / Purpose TN061 is designed for bonding lightweight, flexible components with a thin bond line.

• Maximum adhesion will be achieved after ~ 72 hours. • Avoid stressing the bond in the first 24 hours. Health & Safety Precautions Safety data sheet must be read and understood before use. Technical Service tremco illbruck has a team of experienced Technical Sales Representatives who provide assistance in the selection and specification of products. For more detailed information, service and advice, please call Customer Services on 01942 251400. Guarantee / Warranty tremco illbruck products are manufactured to rigid standards of quality. Any product which has been applied (a) in accordance with...