Catalogs >
Tremco CPG Iberia & Italia - Windows & Facade >
TN015_DS_GB_2019-01-17_WEB

TN015_DS_GB_2019-01-17_WEB
2Pages

Catalog excerpts

illbruckmaking it perfect. Results Self extinguishing, approved to FMVSS302 EPDM closed cell 130 - 170 kg/m3 Single sided Acrylic adhesive Black +10°C -30°C to +90°C 30% Store in shaded dry conditions between +10°C and +20°C 24 months when stored as recommended in original unopened packaging Description TN015 is a single-sided EPDM closed cell foam. Packaging Thickness: 2, 3, 4, 5, 6, 8, 10 and 12 mm Width: 6 to 950 mm Any width within the range noted above can be cut subject to minimum order quantities. Stock size are available and our Customer Service team can supply details as well as advise on cut to order sizes, minimum order quantities and lead time. Technical Information Property Flammability Foam Type Foam Density Adhesive Format Adhesive Type Tape Colour Application Temperatu re Service Temperature Recommended Compressions Storage Shelf Life Preparation • Ensure bonding surfaces are free from irregularities and loose particles which may impair adhesion. • Dust, dirt and grease can be removed using AT115 Solvent Cleaner. Where substrates are sensitive to solvent attack, clean with warm water and allow to dry. • The substrate must always be dry before application of the tape. Application • The exposed adhesive face should be unwound gradually and carefully located onto surface of the substrate. Care must be taken to avoid compressing or stretching the tape during location - this could induce peeling forces and cause the tape to lift from the substrate. • Once the tape has been positioned then apply even pressure throughout the length using a role, starting at the centre and moving to each end to avoid stretching. • With double sided tapes the protective release film is not removed until immediately prior to joint assembly. • The assembly must provide sufficient force to compress the tape by 20% of original thickness for security applications and 30% if weatherseal performance is required. Over compression should be avoided. • Joints may be made by mitring corners or butting the tape ends tightly together. In all cases the tapes should be cleanly cut at slightly longer length than required to ensure compression of the jointing faces and formation of a tight joint. Synthetic Rubber Foam Tape Usage / Purpose TN015 can be used for a wide range of applications requiring a positive water seal and good chemical resistance. It can also be used for open and close seals. Key Benefits • CFC and HCFC free • Good chemical resistance • Self extinguishing

Open the catalog to page 1

illbruck Synthetic Rubber Foam Tape making it perfect. Please Note The adhesive is not UV resistant and should not be exposed to the sun, as degradation of adhesive will occur. Users are advised to conduct their own tests in order to determine the suitability of the product for the particular application. All slitting and length tolerances are to British Standards, but other tolerances are available by request. Health & Safety Precautions Safety data sheet must be read and understood before use. Technical Service tremCO tremco illbruck has a team of experienced Technical Sales...

Open the catalog to page 2

TN015_DS_GB_2019-01-17_WEB 2Pages

Catalog excerpts

All Tremco CPG Iberia & Italia - Windows & Facade catalogs and technical brochures

TN015_DS_GB_2019-01-17_WEB
2Pages