illbruckmaking it perfect. Description LD730 Acrylic Sealant is a one component, gun grade acrylic sealant with fungicide, designed to provide a flexible paintable seal where shrinkage and construction tolerances have left unsightly gaps in building interiors. Colour White Packaging 310 ml cartridges (20 per carton) 380 ml cartridges (25 per carton) Technical Information Properties Composition Specific Gravity Shore A Hardness Tack Free Time Elongation at Break Movement Capability Application Temperature Service Temperature Storage Shelf Life Test Method Results 12.5% +5°C to +40°C -15°C to +75°C Store in dry conditions between +5°C and +25°C. 12 months when stored as recommended in original unopened containers. LD730 Acrylic Sealant Necessary Tools • Cartridge gun and sharp knife. Protective Equipment Use in well ventilated conditions and ensure all recommended protective equipment is worn during handling & use of this product. For full recommendation, refer to safety data sheet. Priming • Very porous surfaces should be primed with WD110. Surface Preparation • Joints should be clean, dry and free from substances likely to impair adhesion. • Loose friable material should be removed. • Wood, plaster and brick, etc., may be damp but not running wet. • Use mechanical abrasion to clean non-porous surfaces if necessary • Joint width and joint depth should not be less than 3 mm to ensure adequate penetration of the sealant and performance. • For sealing around door and window frames the minimum joint width should be 6 mm. Usage / Purpose LD730 is a flexible, mould resistant acrylic sealant for use in internal painting and decorating. It provides an over-paintable seal for filling cracks and gaps around door and window frames, penetrations, damaged plaster and other wall and ceiling surfaces. Key Benefits • Ideal for filling and sealing small cracks and gaps throughout building interiors • Over-paintable: will overcoat with a wide range of paints • Solvent free: no unpleasant solvent odours • Contains fungicide to prevent mould growth

LD730 Acrylic Sealant Joint Backing Please Note • If necessary back fill the joint with polyethylene joint backing in order to control the depth of sealant. Not recommended for areas subject to traffic, abrasion or physical abuse (e.g. floor joints, continuous contact with moisture or external use, where moisture is likely to be present prior to sealant cure). Do not use in conjunction with bitumen or asphalt. Not suitable for contact with water until fully cured. Do not attempt to abrade once cured, or overpaint until a surface skin has formed. For internal use only. Application • The user is...