illbruckmaking it perfect. Description GS360 is a high performance, acetoxy, construction silicone with excellent adhesion, long-term flexibility and weatherproof performance and contains fungicide. Colour White, translucent, grey, brown and black Packaging 310 ml cartridge (20 per carton) Environmental Considerations The use of GS360 in the correct application will give an airtight seal in conformity with the requirements laid down in Approved Document L of the Building Regulations for England and Wales. Technical Information Characteristic Composition Specific Gravity Consistency Shore A Hardness Skin Forming Time Tack Free Time Cure Rate Tensile Strength Modulus at 100% Elongation Elongation at Break Movement Accommodation Elastic Recovery Application Temperature Service Temperature Storage Shelf Life Classification acetoxy cure silicone sealant. White and translucent contain fungicide. 1.01 non-sag 18 5-10 minutes Approximately 30 minutes 1-2 mm/1st day 0.9 MPa 0.38 Mpa 200% 20% 95% +5°C to +40°C -40°C up to +100°C Store in shaded dry conditions between +5°C and +25°C. 18 months when stored as recommended in original unopened containers. Usage / Purpose GS360 is suitable for a wide range of sealing applications, such as: perimeter sealing of door and window frames, sealing and draught proofing of glass and metal assemblies, general construction joints throughout the building. Key Benefits • Bonds to many common construction materials • Rapid curing and permanently flexible • Excellent external weathering properties Necessary Tools • Cartridge gun and sharp knife. Protective Equipment Use in well ventilated conditions and ensure all recommended protective equipment is worn during handling & use of this product. For full recommendation, refer to safety data sheet.

Building Silicone illbruck making it perfect. Priming • GS360 has excellent primerless adhesion to many typical construction materials. For special situations, or if in doubt, please contact tremco illbruck Technical Services Department to discuss your requirements. Joint Design Considerations • Joint design to be in accordance with BS 6093. • For the purposes of joint width calculation in BS 6093, the MAF of GS360 is 20% • Width to depth ratio of GS360 should be 2:1 • The minimum contact area with any substrate (including for fillet joints) should be determined by the quality of the bond. If...