illbruckmaking it perfect. Description GS200 is a gun grade, acetoxy cure silicone sealant with fungicide. Colour Translucent and white Packaging 310 ml cartridge (20 per carton) Technical information Characteristic Standard Composition Specific Gravity Consistency Shore A Hardness Skin Forming Time Tack Free Time Cure Rate Tensile Strength Modulus at 100% Elongation Elongation at Break Movement Accommodation Elastic Recovery Application Temperature Service Temperature Storage Shelf Life acetoxy cure silicone sealant with fungicide 0.98 non-sag 18 25 minutes Approximately 40 minutes 1 - 2 mm/1st day 0.6 N/mm2 0.36 N/mm2 150% 20% 95% +5°C to +40°C -40°C up to +100°C Store in shaded dry conditions between +5°C and +25°C. 18 months when stored as recommended in original unopened containers. Necessary Tools • Cartridge gun and sharp knife. Protective Equipment Use in well ventilated conditions and ensure all recommended protective equipment is worn during handling & use of this product. For full recommendation, refer to safety data sheet. Priming • GS200 has excellent primerless adhesion to many typical construction materials. For special situations, or if in doubt, please contact Tremco CPG Technical Services Department to discuss your requirements. Joint Design Considerations • Joint design to be in accordance with BS 6093. • For the purposes of joint width calculation in BS 6093, the MAF of GS200 is 20% • Width to depth ratio of GS200 should be 2:1 Usage / Purpose GS200 is a rapid curing, sanitary grade silicone sealant with excellent resistance to mould and mildew. It is ideal for applications in: bathrooms, showers and wet rooms; kitchens; changing areas and hospital sluice rooms. Excellent un-primed adhesion to glass, ceramic tiles, many plastics and paint coatings, vitrified substrates. Key Benefits • Contains powerful fungicide to prevent mould growth • Wide service temperature range: -40°C to +100°C • Accommodates joint movement up to 20% • Excellent resistance to detergents and cleaning

GS200 Sanitary Silicone • The minimum contact area with any substrate (including for fillet joints) should be determined by the quality of the bond. If in doubt, please contact Tremco CPG. • Sealant width not to be less than sealant depth. • Joint faces should be clean, dry and free from dust, oil, grease, old sealant and any traces of contaminant which may affect adhesion. Any previously applied sealant must be mechanically removed. • Thoroughly clean with a suitable cleaning solvent using the two cloth method, using one cloth dampened with the cleaning product to lift contaminants and a second...