illbruckmaking it perfect. Description CT600 is a high strength contact adhesive made from a blend of synthetic rubber and resin that is supplied in an easy-to-use 500 ml handheld sprayable canister. Colour Light yellow Packaging 500 ml can (12 per carton) Technical Information Characteristic Composition System Specific Gravity Viscosity (at 20°C) Flash Point Coverage Drying Time (at 20°C) Results (Typical Values) A blend of synthetic rubber and resin Solvent evaporation 1.22 Sprayable -40°C 5 m2 of bonded area per 500 ml canister 2 - 3 minutes Application Temperature Shelf Life 12 months when stored as recommended in original, unopened containers Sprayable Contact Adhesive Necessary Tools • Hand held canister - no tools required. Protective Equipment USE IN WELL VENTILATED CONDITIONS and ensure all recommended protective equipment is worn during handling & use of this product. For full recommendation, refer to safety data sheet. Preparation • Surfaces must be clean, dry, smooth, firm and free from any traces of contaminant which may affect adhesion. • Metal surfaces must be degreased using AT200 High Strength Cleaner and completely dry before bonding. Application • Shake the can thoroughly before use. • Remove the cap and turn the nozzle to the desired spray width. • Hold the can 20 cm to 25 cm away from the surface and spray onto the substrate to be bonded. • After use turn the can upside down and press the spray nozzle until it is clear of adhesive. This will prevent a blockage in the nozzle. ONE-WAY WET STICK: • Apply to porous materials such as cardboard, fabric,paper, etc., apply to one surface and press both surfaces together immediately. Usage / Purpose CT600 is a high strength contact adhesive in an easy-to-use 500 ml handheld canister. It is ideal for quick and simple bonding of many common materials, including: wood, cardboard, fibrous insulation materials, paper, plastics, canvas, cork, rubber, fabrics and foam, either to themselves or onto brickwork, concrete, stone and plaster. Key Benefits • A powerful contact adhesive in a convenient easy-to-use 500 ml canister • Dries rapidly to form a high strength bond with porous and non-porous materials • Integral adjustable nozzle allows precise control of the spray pattern to suit any particular job • Versatile formulation - can be used as a one-way, contact or temporary tacking adhesive • Excellent coverage - up to 5 m2 of bonded area from a single canister

TWO-WAY WET STICK: • For bonding non-porous substrates, apply to both surfaces, allow to dry for 2 to 3 minutes and then press both surfaces together. TEMPORARY BOND: • Spray on to one surface, allow the coating to dry for 3 to 5 minutes and press into position. Cleaning Clean any surplus adhesive using AT200 High Strength Cleaner. Please Note Not suitable for bonding expanded polystyrene. Health & Safety Precautions Safety data sheet must be read and understood before use. Extremely flammable - keep away from open flames and other ignition sources. Technical Service Tremco CPG UK Limited has...