Catalogs >
Toto >
WASHLET® Fit Chart

WASHLET® Fit Chart
8Pages

Catalog excerpts

WASHLET® COMPARISON CHART SW3056 (Contemporary) SW3046 (Contemporary) SW3054 (Classic) SW3044 (Classic) REAR CLEANSE SOFT REAR CLEANSE FRONT CLEANSE WIDE FRONT CLEANSE OSCILLATING CLEANSE PULSATING CLEANSE CLEANSE INSTANTANEOUS WATER HEATING WATER PRESSURE CONTROL WATER TEMPERATURE CONTROL WAND POSITION ADJUSTMENT AIR PURIFIER (DEODORIZER) AIR HEATED SEAT SEAT AIR DRYER AIR TEMPERATURE CONTROL HEATED SEAT TEMPERATURE CONTROL SOFTCLOSE SEAT AND LID SEAT SENSOR AUTOMATIC FLUSH NIGHT LIGHT AUTOMATIC OPEN AND CLOSE LID REMOTE CONTROL REMOTE CONTROLLED SEAT ON-DEMAND WAND CLEANING REMOTE CONTROL...

Open the catalog to page 2

REAR CLEANSE SOFT REAR CLEANSE FRONT CLEANSE WIDE FRONT CLEANSE OSCILLATING CLEANSE PULSATING CLEANSE CLEANSE INSTANTANEOUS WATER HEATING WATER PRESSURE CONTROL WATER TEMPERATURE CONTROL WAND POSITION ADJUSTMENT AIR PURIFIER (DEODORIZER) AIR HEATED SEAT SEAT AIR DRYER AIR TEMPERATURE CONTROL HEATED SEAT TEMPERATURE CONTROL SOFTCLOSE SEAT AND LID SEAT SENSOR NIGHT LIGHT REMOTE CONTROL SIDE PANEL SIDE PANEL SIDE PANEL SIDE PANEL SIDE PANEL WAND CLEANING MODE SELF-CLEANING WAND ENERGY-SAVER TIMER AUTO ENERGY SAVER ON/OFF BUTTON REMOTE CONTROL AUTOMATIC FLUSH AUTOMATIC OPEN AND CLOSE LID REMOTE...

Open the catalog to page 3

WASHLET® COMPATIBILITY CHART SIZE

Open the catalog to page 4

ENTRADA TWO- PIECE TOILETS WALL-HUNG TOILETS *Extension kit THU9090R required **Extension kit 9AU321-A req

Open the catalog to page 5

WASHLET® INSTALLATION REQUIREMENTS For when your existing toilet is in need of an upgrade. The following four-part diagram details the approximate measurements and requirements for installing most WASHLET models on existing toilets. Note that some styles of toilets may not allow the WASHLET to fit properly due to certain contours where the tank meets the bowl. ELONGATED FRONT WASHLET FRONT OF TANK 2” Min. (50 mm) CENTER OF HOLE Elongated seats approximately 18-1/2 inches (470 mm) from mounting holes to front of bowl. CENTERS OF SEAT MOUNTING BOLT HOLES Minimum of 2 inches (50 mm) from front...

Open the catalog to page 6

ROUND FRONT WASHLET WASHLET C200 & C100 FRONT OF TANK 2-1/2” Min. (64 mm) CENTER OF HOLE FRONT OF TANK 1-3/4” Min. (45 mm) CENTER OF HOLE Round seats approximately 16-1/2 inches (420 mm) from mounting holes to front of bowl. CENTER OF SEAT MOUNTING BOLT HOLES Minimum requirement for front face of tank to the center of mounting holes: C100 & C200: 2-1/2 inches (64 mm) S350e & S300e: 1-3/4 inches (45 mm) EDGE OF FLAT BOWL SURFACE Approximately 5-1/2 inches (140 mm) from the centers of the seat mounting holes. Minimum of 8 inches (203 mm) of open space from center of toilet to edge of flat...

Open the catalog to page 7