PRODUCT TECHNICAL SHEET TECHNICAL DRAWING PRODUCT FAMILY: THERMOSTATIC MIXERS - MIX THERMO-A SERIES CODE: TMA112M60 DESCRIPTION: Anti-condensation thermostatic mixer "L" 60°C, G 1” ½ outlet connection with flange for pump connection. HYDRAULIC PERFORMANCES: Particularly suitable for closed circuits where you must constantly adjust the temperature of the return to the boiler. Their use can improve the performance of heat generators by increasing the speed of set up of the system and limiting condensation. APPROVALS/CERTIFICATIONS: TUV system certification UNI EN ISO 9001:2008. PRODUCT FEATURES: The mixer is factory set at a temperature of 60 + 5 ° C and it is suitable for solid fuel generators. The operation provides that up to 60 ° C, the valve keeps the by-pass of the circuit open, while maintaining the hot water in the boiler and avoiding the condensation. However, the valve progressively supplies the installation, allowing the system to reach its full operation. At a temperature between 60 and 65 ° C, the valve gradually opens the circuit progressively closing the by-pass. Over 65 ° C the by-pass is completely closed and the valve delivers the water to the installation so that the temperature can rise up to the maximum value, at this point the system is completely operative. Connections are: RED 1"G male, BLU 1"1/2 G male, mix flage pump connection suitable for 1"1/2 nut. Separately KIT 10 can be purchased: 1"1/2 nut for outlet flange. The shape of the body with 90° input connections (red-blue) is particularly suitable in all applications in which the outlet and inlet pipes are positioned in parallel, or in case the valve shall be installed in temperature control units where the centre distance of mm 125 between the feed and return pipes must be respected. TECHNICAL DATA: Inlet: 1" G male RED, 1"1/2 G male BLUE Outlet: flange for pump connection 1"1/2 nut (not included) Maximum working pressure: 10 bar Reccomended pressure: 0 - 5 bar Maximum inlet pressure: 90°C Setting: 60+5°C Antitampering cap KV: 2,7 m3/h FIXING/INSTALLATION: Follow the instructions for the connection kit: RED: inlet hot water (feed) BLU: inlet cold water (return) MIX = outlet mixed water - If the water contains corpuscles we reccomend to install filters. The above mentioned information cannot be considered as binding. Thermomat Srl APPROVATO reserves the right to make technical and aesthetic changes without any prior notice. THERMOMAT SRL Via M. Curie, 7 - 46034 Borgo Virgilio (Mantova) ITALY Tel. + 39 0376 4473 www.thermomat.com - e-mail: info@therm

PRODUCT LISTING: Body: chrome-plated forged brass UNI EN 12165 CW617N – sandblasted Shutter and internal elements: brass UNI EN 12164 CW614 N Spring: stainless steel INOX AISI 302 o'ring: NBR Knobs: Nylon PA6 Thermo-sensitive element wax The above mentioned information cannot be considered as binding. Thermomat Srl APPROVATO PRODUCT PACKING: Packed according to needs Weight 0,6 kg (without packing) reserves the right to make technical and aesthetic changes without any prior notice. THERMOMAT SRL Via M. Curie, 7 - 46034 Borgo Virgilio (Mantova) ITALY Tel. + 39 0376 4473 www.thermomat.com - e-mail:...