product technical sheet article code product family product line versions materials description certifications fixing Ever Life Design Taps RUMC301 - washbasin mixer tap, chrome plated brass RUMC302 - washbasin mixer tap, matt white painted brass RUMC303 - washbasin mixer tap, matt black painted brass RUMC304 - washbasin mixer tap, nikel plated brass Brass, zama, other. Mixer tap for installation on basin. Complete with drain 1 “1/4 with pop. Base diameter 47 mm. total height 160 mm. Distance aerator-body center 122 m. maximum thickness of 40 mm installation plan. 3/8 “water connections. Cartridge Ø 25 mm. TUV system certification UNI EN ISO 9001:2008. Before doing any operation, ensure that the mains water supply is off. Before making any inlet pipe connections, all supply pipes MUST be Thoroughly flushed to remove debris. Failure to do this could result in damage to the cartridge and components or low flow from the mixer. Insert the Hot and Cold flexible tubes and the threaded rod into the body of the mixer Position the base ring and the surface washer onto the bottom of the mixer and place the assembly onto the basin/counter ensuring that the washer is in between the surface and the mixer. From the underside, place the ‘O’ Ring followed by the Metal Washer onto the threaded rod, then tighten to clamp the mixer to the basin/counter with the back nut, being careful not to over tighten. Install the waste ensuring that the foam washer is in between the waste and basin on the top portion of the waste, the rubber washer is to be placed under the basin before the bottom part of the waste is tightened up. Take care not to over tighten. Insert the vertical pop up rod into the mixer and connect to the horizontal rod on the waste body using the connector provided. Slide down push rod into rod link then push both roads down to the furthest point and tighten. Install the flexible pipes to the water supply and test leaks on the connections Make a proper cleaning with soap and water, do not use aggressive, abrasive, corrosive, acid, acetone, paint thinner, etc. Do not scratch the paint / chrome / nickel. Periodically check the correct mounting and installation robustness. Do not use the product for purposes other than those intended. ST_PRODOTTO: RUMC301-RUMC302-RUMC303-RUMC304 - REV.00 - 13/06/2017 - APPROVED T.D. The above mentioned information cannot be considered as binding. Thermomat Saniline srl reserves the right to make technical and aesthetic changes without any prior notice. Ever by Thermomat Saniline s.r.l. | Mantova | Italy www.everl