Catalogs >
TECHNOKOLLA >
TECHNOSTAR HD Ver:09/13 209

TECHNOSTAR HD Ver:09/13 209
4Pages

Catalog excerpts

TECHNOSTAR HD Highly deformable adhesive with ultra-low dust emission used in layers up to 15 mm thick. Especially suitable for fixing porcelain stoneware and natural stone in large sizes. Fixing on façades, heating screeds, in swimming pools and for industrial floors. bonding agents and adhesives

Open the catalog to page 1

MAIN FEATURES Ultra-low dust emission Monocomponent Can be used in thick layers Frost proof No vertical creep Highly deformable Layers up to 15 mm thick APPEARANCE White or grey powder STORAGE 12 months in dry place FIELDS OF USE - Fixing ceramic tiles of all types, even large sizes, on walls and floors, indoors and outdoors. - Suitable for use when high performance is required, such as: tile laying in industrial environments, swimming pools or facades. - Over-tiling on top of old ceramic tiles without the use of primer. - Suitable for fixing thin porcelain stoneware slabs. - Fixing natural...

Open the catalog to page 2

RECOMMENDED ACCESSORIES HOW TO PREPARE THE MIXTURE Blend TECHNOSTAR HD with approximately 7.25 l of clean water (29±1%). Blend until mixture is homogeneous and lump-free. It is advisable to use blender at low speed (approx. 500 rpm) as high speed will reduce the mechanical characteristics of the product. Wait 5-10 minutes, then stir the product briefly again before applying. The creamy paste obtained can be easily applied by trowel and possesses optimum thixotropy. WARNINGS AND RECOMMENDATIONS It is always advisable to apply two coats when laying tile sizes measuring 900 cm² or larger. Do...

Open the catalog to page 3

technostar hd TECHNICAL DATA Curing time Open time Adjustability time Floor tiles can be grouted Wall tiles can be grouted *After 14 days (21 days for tanks and swimming pools) Creep on vertical wall Initial tensile strength Tensile strength after the action of heat Tensile strength after immersion in water Bond after freezing/thawing cycles Transverse deformation ° according to standard "EN 12004" * these time intervals refer to a temperature of 23°C-50% R.H.. They become shorter with higher temperatures and longer at lower temperatures. SPECIFICATION Ceramic floor and wall tiles must be...

Open the catalog to page 4

TECHNOSTAR HD Ver:09/13 209 4Pages

Catalog excerpts

All TECHNOKOLLA catalogs and technical brochures

TECHNOSTAR HD Ver:09/13 209
4Pages