TECHNORAP Quick setting powder adhesive with high polymeric content for fixing ceramic tiles. Suitable for porcelain stoneware, over-tiling and on heating screeds. bonding agents and adhesives

technorap EN 12004 with TC-LASTIC MAIN FEATURES Quick-setting Monocomponent Layers up to 10 mm thick Frost proof No vertical creep APPEARANCE Grey powder STORAGE 6 months in dry place FIELDS OF USE -- Quick fixing ceramic tiles of all types, even large sizes, on indoor and outdoor walls and floors. -- Over-tiling on top of old ceramic tiles without the use of primer. -- Suitable for use when high performance is required within a short time, such as: tile laying in industrial environments, swimming pools or facades. -- Fixing natural stone and marble, so long as they are not affected by water....

RECOMMENDED ACCESSORIES HOW TO PREPARE THE MIXTURE Blend TECHNORAP with approximately 6 l of clean water per bag (24±1%) until mixture is homogeneous and lump-free. It is advisable to use blender at low speed (approx. 500 rpm) as very high speed will reduce the mechanical characteristics of the product. Wait 3-5 minutes, then stir the product briefly again before applying. The creamy paste obtained can be easily applied by trowel and possesses optimum thixotropy. WARNINGS AND RECOMMENDATIONS It is always advisable to apply two coats when laying tile sizes measuring 900 cm² or larger. Do not apply...

technorap TECHNICAL DATA Curing time Open time Floor tiles can be grouted Wall tiles can be grouted *After 48 h (72 h tanks and swimming pools) Creep on vertical wall Initial tensile strength Tensile strength after the action of heat Tensile strength after immersion in water Bond after freezing/thawing cycles ° according to standard “EN 12004” * time intervals refer to a temperature of 23°C-50% R.H.. They become shorter with higher temperatures and longer at lower temperatures. SPECIFICATION Ceramic floor and wall tiles must be fixed with class “C2FT cement-based powder adhesive according to...