AER
2Pages

Stainless steel pipe reinforcement , the section of which is square 20/20/2 or 15/15/2 , ; used to bear shear or traction forces. Fabric sleeve wraps the whole anchor and is adapted to the drilling diameter which depends on the existing support . No injection pipe , anchor is injected through the reinforcement pipe. This type of anchor is the ideal answer to the following construction problems: - outside or inside fastening - reinforcement by hooping existing structures - nailing of faqade elements - consolidating or fastening of projecting elements - safety back-up before works - spreading of specific charges - fastening of opposed facings separated by unstable elements - cracks repair . The AER carries traction as well as shear forces . Typical performances can be adapted by increasing the drilling diameter and using the right sleeve . Maximum drilling diameter remains 50 mm for load bearing cases , especially when number of anchors to spread it is high . The AER is very efficient when masonry is in bad shape . The AER is ideal for fastening corner stones and tying fronts together on cross walls. Steel Anchors

Ces deux types d’ancrages s’appliquent particulièrement The square les cas suivants: the load bearing capacity dans section increases and reduces the bending deformations. The AER can be injected in all directions including vertical , - épinglage extérieur ou intérieur. head down . In vertical installations head down , - renforcement, frettage d’existant. the anchor gets stucked at the bedinning of the injection and can be - cloutage risk of falling down . released without d’appareillage de façade. This type of installation avoids large disassembling of the existing - consolidation et...