>Dual flushStelescopic OPTIMA ADJUSTABLE ADJUSTABLE TELESCOPIC OVERFLOW TECHNICAL EQUIPMENT an be installed into ceramic or plastic cisterns, for replacement or as original equipment C ush button: dual flush P Actuation effort below 20 Newton or lid holes ranging from 16 to 50mm, with or without collar depending on the diameter F Button off-center +/- 15mm tirrup: adjustable in increments of 10 mm S djustable overflow, in increments of 10mm A djustable small flush, from 2l to 4.5l (no cutting required) A djustable deadwater level up to 60 mm A igh flush rate of 3.5l/s H Foam pan seal supplied for compensating pan irregularity RAISED BUTTON AVAILABLE (see page 55 for more details) A Compatible with: - id hole Ø (A) from L 16 to 50mm - rainage hole Ø (D) D from 58 to 72mm Adjustable height (B): - ith collar: from W 282 to 432mm (lid hole Ø ranging from 16 to 38mm and 43 to 50mm) - ithout: from 300 to 445mm W (lid hole Ø ranging from 39 to 42mm) Adjustable telescopic overflow height (C): 185 to 325mm B Optima S flush valve available in a pack with the Delayed Action 99T BP inlet valve OPTIMA S Dual flush valve NF and WRAS certified, compact and water saving. The stirrup fixes the cistern lid once the button is screwed down and enables a non alignment position. Adjustable button with optional collar. Adjustable height from 282 and 432 mm, lid hole from 16 to 50, discharge hole from 58 to 72 mm. Adjustable : small flush, over flow (with no cut), dead water level. Ref. Pallet quantity Optima S raised button Inner bottom of cistern