8.6 Schlüter® -KERDI-SHOWER
4Pages

NNOVATIVE PROFILES FLOOR LEVEL SHOWERS system for the construction of floor level showers with ceramic tiles. The sloped trays, which are optionally available with additional levelling boards, are offered In dif- ferent dimensions. The matching floor drain available as a set. Depending on the condi- tions of the construction site, other variants well. Various sets of Schluter®-KERDI are available for waterproofing the wall areas. The sloped trays already have the necessary gradient of > 2% (except sloped trays for long sides in the dimension 90 x 180 cm). The drain body and the drainage pipe are inserted Into the levelling board, which rep- resents the lowest possible construction height and can be adjusted, for example with a mortar layer. The available base dimensions are: Smaller dimensions can easily be cut to size with a utility knife. The material features prepared cutting grooves for round cuts with The matching floor drain for the system, zontal drainage), has a drain capacity of KERDI-DRAIN product family Is available for higher drain capacity needs, special fire protection requirements, vertical drains, or other special concerns. Its particularly easy and reliable installation. Together with Schluter®-KERDI waterproof- ing component, this meets the require- ments of the German Certificate of National Technical Approval (abP) for Category A waterproofing assemblies. The system Horizontal drainage Schlüter»-KERDI-SHOWER sloped tray Vertical drainage

Set levelling board In place Insert drain body Place sloped tray on top Install bonding flange Install waterproofing Insert the stainless steel a Schlüter®-KERDI waterproofing collar b Schlute^-KERDI-SHOWER sloped tray c Schluters-KERDI-SHOWER levelling board The levelling board and the sloped board consist of pressure resistant, expanded polystyrene foam (EPS). The drain body Is made of high Impact polypropylene (PP). The bonding flange consists of acryl-nltrile butadiene styrène (ABS) and features an attachment flange with a fleece coated surface. The Schluter®-KERDI collar for bonded...

and is able to bear the weight of wheel- chairs. If higher traffic loads are expected, an additional load distribution layer or larger tile formats may be required. Use system approved thin set mortars for areas that require waterproofing in accordance with general certificate of national technical approval or CE con- formity. Please contact us at the address shown in this data sheet for more details. As part of the installation of the floor tiles, press the drain grate frame into the thin bed mortar until flush with the tile cover- ing. Tile adhesive can be applied below the grate frame...

1. The drain body and the drainage pipe are inserted into the levelling board. The board has a custom fit opening for the drain body. The board also features a pipe cut out that runs at a right angle to the wall and diagonally to the wall corner. 2. Use a utility knife to make the neces- sary cut outs along the embossed groove. The board, which Is divided Into two parts for easier handling, also has a tongue and groove connection. The sloped board is designed with the necessary gradient of > 2% (except long side sloped trays 90 x 180 cm). It features a custom-fit opening for the...