14.1 Schlüter® -SHOWERPROFILE-S / -R
2Pages

{{requestButtons}}

Catalog excerpts

14.1 Schlüter® -SHOWERPROFILE-S / -R - 1

INNOVATIVE PROFILES FLOOR LEVEL SHOWERS part profile with a tapered edge, designed to cover adjoining tile edges that become exposed as the shower floor slopes to accommodate drainage to the Schluter®- KERDI-LINE. The tapered profile features a visible surface of brushed stainless steel and a fleece fabric on the reverse for bond- ing with the tile adhesive. It Is designed to be Inserted into the U-shaped groove of the matching hard PVC support profile. The profile can be used for lateral transitions to the wall or the adjoining floor. The PVC support profile is available In 6 different thicknesses from 3 mm to 22 mm to match the thickness of the tiles Installed In the floor of the shower. The tapered pro- file Is available In longer sections of 120 narrow end. It features a slope of 2% (i.e. the height changes by 2 mm across every 10 cm of length). The profile Is simply cut to the required height and length at the narrow and broad ends. In addition, the height can be further adjusted by Inserting the profile Into the U-shaped support section to various part wall transition profile made of brushed stainless steel for covering the exposed wall area where the floor slopes down to a perimeter linear drain. A fleece fabric Is laminated on the reverse of the profile for bonding with the tile adhesive. The two part can be seamlessly adjusted to any height two versions). The profile Is available In made of stainless steel material no. 1.4301 (V2A) and have a fleece fabric laminated on the reverse for bonding with the tile adhesive. The support profile of Schlüter®- SHOWERPROFILE-S is made of rigid recy- cled PVC. The visible surface of the profile Is covered with a protective foil. The suitability of the profiles must be veri- fied based on the anticipated chemical and mechanical stresses. The tapered profile less steel V2A (material no. 1.4301) is particularly suitable for high mechanical

Open the catalog to page 1
14.1 Schlüter® -SHOWERPROFILE-S / -R - 2

impact or special exposure to chemicals. However, even stainless steel is not resist- affected by hydrochloric and hydrofluoric acid or certain chloride and brine concen- trations, which may be present in deter- gents or swimming pools. Special antici- pated stresses should therefore be verified The protective foil must be removed before Installation. 1. After cutting to length, press the trap- ezoid perforated anchoring leg of the support profile into the previously applied tile adhesive on the floor and 2. Measure the required length and height of the tapered profile (front: lowest...

Open the catalog to page 2

All Schluter-Systems catalogs and technical brochures