GLASS CLAMP FACADES GLASS CLAMP FACADES

GLASS CLAMP FACADES A new fagade system for structural glazing with a unique aesthetic design incorporating gentle curves and exceptional finish. SADEV clamping systems guarantee performance & design, with maximum transparency. Thanks to a new fixing process, glass panels are supported even in cases of heavy applied loads. Requires no glass drilling, allowing easy and quick installation. Parts are made out of 316 Stainless Steel with a brushed finish (standard) allowing installation in both interior and exterior environments and nearly any condition. The fittings dimensions have been calculated...

Typical facade GLASS CLAMP FACADES

Designation : stainless steel clamp spider GLASS SIDE VIEW Omega cone available as option (see p. 8.24) (§£

GLASS CLAMP FACADES Mechanical performances Suggested mounting Mounting the spiders to the structure f mounting directly to the structure antl-rotatlon pins are recommendec to prevent the clamps from rotating. The diameter of the antl-rotatlon olns Is 6 mm. Do not pre-drlll the holes for the pins In your structure oefore mounting spiders. Drill bits and antl-rotatlon are provided An alternate attachment Interface (Omega) Is available. The Omega nterface allows for vertical adjustment of the clamp fitting to account for tolerances In the drilling of the structural steel The fixing of the spider...

Designation : stainless steel clamp spider GLASS SIDE VIEW Omega cone available as option (see p. 8.24)

GLASS CLAMP FACADES Mechanical performances LOAD PARALLEL LOAD PARALLEL LOAD PERPENDICULAR LOAD PERPENDICULAR Suggested mounting Mounting of the spiders on the structure f mounting directly to the structure antl-rotatlon pins are recommendec to prevent the clamps from rotating. The diameter of the antl-rotatlon olns Is 6 mm. Do not pre-drlll the holes for the pins In your structure oefore mounting spiders. Drill bits and antl-rotatlon are provided An alternate attachment Interface (Omega) Is available. The Omega nterface allows for vertical adjustment of the clamp fitting to account for tolerances...

Technical advice available online at: www.sadev.com MONTI M14 OPTION 3025 M14 OPTION

GLASS CLAMP FACADES Mechanical performances Suggested mounting nstall the nut (# 6) + 1 washer (#7) on part (#1) nstall through the hole In the support or spider casting. Spacer E over threads to pre- vent fitting from fully tightening on support for differential movements between structure and glass support (supplied on request). Adjust depth In or out as needed Mounting other washer (#7) and lock washer (#8) + nut (#9, 10 (standard), or 11) anc torque to 60 Nm (45 ft lbs). Set glass on gravity shelf with EDPM (#5) setting block Mount the external disc (#2) with EPDM (#4) washer between glass...

GLASS CLAMP FACADES