Catalogs >
Ronacrete Limited >
RonaDeck Resin Bonded Seal Coat UV

RonaDeck Resin Bonded Seal Coat UV
2Pages

Catalog excerpts

RonaDeck Resin Bonded Seal Coat UV Polyurethane sealer for RonaDeck Resin Bonded Surfacing system FEATURES • clear polyurethane coating • UV stable • sealer for RonaDeck Resin Bonded Surfacing • improved aggregate retention • increased abrasion and frost resistance • improved chemical resistance and ease of cleaning • 1 or 2 coat application • ready to use RonaDeck Resin Bonded Seal Coat UV is a clear polyurethane sealer suitable for internal and external use. Use to seal, bind and protect RonaDeck Resin Bonded Surfacing surfaces. Used as a two coat seal the following benefits can be achieved: • improved aggregate retention and weathering resistance • increased abrasion resistance • surface is easier to clean • chemical resistant against a wide range of chemicals and solvents - check with the Ronacrete Technical Department Physical Properties Touch Dry Re-coatable 90% Cure Flash Point Application Temperature Thoroughly clean all surfaces to remove loose material, dirt, dust, grime etc. Remove any standing water to leave the surface as dry as possible. Any moss, algae or fungal growth should be treated with RonaBond Fungicidal Treatment followed by hosing, stiff brushing and drying. apply to dry surfaces only flammable - do not use near naked flame protect from rain and adverse weather until fully cured 1. Apply the first coat of RonaDeck Resin Bonded Seal Coat UV using a short nap roller at the appropriate rate. Coverage rate is determined by the size of the applied aggregate and is best determined by practical trial. Resin Bound and Bonded Surfacing Continued on following page... Other Ranges—Concrete Repair and Coatings, Screeds, Waterproofing and Tanking, and, Flooring and Bedding

Open the catalog to page 1

RonaDeck Resin Bonded Seal Coat UV Polyurethane sealer for RonaDeck Resin Bonded Surfacing system Instructions for Use (continued) 2. If applying a single coat only allow to cure for 2-5 hours then traffic. If applying a second coat allow the first coat to cure for at least 1 hour but not more than 24 hours. 3. Apply the second coat in the same manner as described in 1. above. 4. Allow to cure for 2-5 hours then traffic 5. Avoid over treating as this will create a surface glaze Note: The application of RonaDeck Resin Bonded Seal Coat will change the appearance of the aggregates and...

Open the catalog to page 2

RonaDeck Resin Bonded Seal Coat UV 2Pages

Catalog excerpts

All Ronacrete Limited catalogs and technical brochures

RonaDeck Resin Bonded Seal Coat UV
2Pages