RonaDeck Resin Bonded Pore Filler Pore and void filler prior to application of RonaDeck Resin Bonded Surfacing ■ scrape on/scrape off pore filler ■ use prior to application of RonaDeck Resin Bonded Surfacing ■ reduces amount of resin needed on open face • quick curing ■ allows overlay within 1 -2 hours Description RonaDeck Resin Bonded Pore Filler is a fast cure cementitious pore filler for filling pores and voids in the matrix of surfaces prior to the application of RonaDeck Resin Bonded Surfacing. It is used prior to the application of RonaDeck Resin Bonded Surfacing to fill holes and voids in the surface and considerably reduce the amount of RonaDeck Resin Bonded Surfacing Resin used on open texture surfaces. RonaDeck Resin Bonded Pore Filler has excellent adhesion to bituminous and cementitious surfaces. The speed of RonaDeck Resin Bonded Pore Filler enables it to be overlaid within 1 - 2 hours at 10°C to 20°C. It is supplied as a two component product, powder and liquid. Surfaces on which RonaDeck Resin Bonded Pore Filler is applied must be well constructed, structurally stable with good cohesive strength and suitable to receive a bonded high strength surfacing. Weakness in or on the surface is likely to result in failure. Physical Properties Working Time Overlay Time 25kg; supplied as powder and liquid Instructions for Use Refer to the RonaDeck Resin Bonded Surfacing data sheet for full information on surface preparation and testing. Repairs must be carried out with other materials before application. Surfaces must be cleaned of loose material, oil, grease and dampened with clean water prior to applying RonaDeck Resin Bonded Pore Filler. RonaDeck Resin Bonded Pore Filler can be mixed using a drill with suitable paddle attachment, in a forced action mixer or by hand. The working time is Resin Bound and Bonded Surfacing Continued on following page... Other Ranges—Concrete Repair and Coatings, Screeds, Waterproofing and Tanking, and, Flooring and Beddi

RonaDeck Resin Bonded Pore Filler Pore and void filler prior to application of RonaDeck Resin Bonded Surfacing Instructions for Use (continued) approximately 10-20 minutes at 20°C. Working time will be affected by material and ambient temperature and mixing time. It must be mixed close to the area of application so that it can be placed and finished before initial set. Excessive mixing should be avoided as this will generate a greater exotherm and accelerate the set. To mix, place the RonaDeck Resin Bonded Pore Filler in to the mixer or mixing container, dry mix until components evenly dispersed...

RonaDeck Resin Bonded Pore Filler Pore and void filler prior to application of RonaDeck Resin Bonded Surfacing Site Attendance When on site Ronacrete representatives are able, if asked, to give a general indication of the correct method of installing a Ronacrete product. It is important to bear in mind that Ronacrete Ltd is a manufacturer and not an application contractor and it is therefore the responsibility of the contractor and his employer to ensure he is aware of and implements the correct practices and procedures to ensure the correct installation of the product and that liability for...