RonaBond Slurry Coat Prepacked mortar for façade levelling prior to painting / coating FEATURES ease of application prepacked for control and convenience waterproof frost proof apply 1-3mm thick as a levelling slurry coat by brush or roller may be finished with float, trowel or stipple brush forms textured substrate prior to application of protective/decorative coating RonaBond Slurry Coat is a pre-packed slurry coat for surface finishing prior to coating. It can be applied to concrete to fill blemishes and blow holes, pebble nests and larger static cracks. Also apply over the entire surfaces to achieve a textured or smooth surface prior to application of paint applied coatings such as RonaBond Crack Bridging Anti-Carbonation Coating WB, RonaBond AntiCarbonation Coating and RonaBond Masonry Coating. RonaBond Slurry Coat is supplied pre-packed requiring on site addition of of a controlled quantity of water. Physical Properties min/max build per layer ISAT (ml/m2/sec) min/max application temperature packaging water addition per pack (litres) yield packs required per m³ coverage per pack * up to 3mm per layer of RonaBond Slurry Coat is achievable on a flat surface Preparation The substrate on which RonaBond Slurry Coat is being applied must be clean, sound and stable. Surfaces should be prepared by high pressure water or wet or dry blasting or similar means to remove previous coatings and dirt and deleterious material. Oil or grease should be removed by the use of a suitable degreaser. Dense, smooth surfaces should be textured by grit blasting or other means to give a mechanical key. The surface should be left damp but not running wet or dry. Concrete Repair and Coatings Continued on following page... Other Ranges—Resin Bound and Bonded Surfacing, Screeds, Flooring and Bedding, and Waterproofing and Tanking

RonaBond Slurry Coat Prepacked mortar for façade levelling prior to painting / coating Instructions for Use (continued) Mixing RonaBond Slurry Coat is supplied as dry powder. Mix the powder with 8 - 10 litres of clean potable water using a slow speed drill and paddle mixer for 2 - 3 minutes (depending on mixer efficiency) to achieve an even slurry consistency. Application Apply the mixed material to the prepared and dampened surface by brush, roller or airless spray ensuring total coverage and a uniform surface appearance. Application method and technique will determine the finished texture....

RonaBond Slurry Coat Prepacked mortar for fagade levelling prior to painting / coating Site Attendance When on site Ronacrete representatives are able, if asked, to give a general indication of the correct method of installing a Ronacrete product. It is important to bear in mind that Ronacrete Ltd is a manufacturer and not an application contractor and it is therefore the responsibility of the contractor and his employer to ensure he is aware of and implements the correct practices and procedures to ensure the correct installation of the product and that liability for its correct installation...