RonaBond Re-Profiling Mortar
4Pages

RonaBond Re-Profiling Mortar Pre-packed polymer modified mortar for re-profiling vertical and overhead surfaces Excellent resistance to shrinkage Can be applied from 3mm Up to 30mm thick Excellent substrate adhesion Pre-packed for ease of use and consistent performance RonaBond Re-Profiling Mortar is a pre-packed mortar requiring only the addition of clean water. It is designed to produce a smooth, level finish for concrete and masonry surfaces. The finished product can be over-coated or can be left as the finished surface. RonaBond Re-Profiling Mortar can be used as a levelling mortar for prepared vertical and overhead surfaces prior to the application of protective coatings or paints. RonaBond Re-Profiling Mortar can be applied to vertical surfaces from a thickness of 3mm to 30mm or to overhead surfaces from 3mm to 20mm. Test Data Min / max thickness vertical Min / max thickness overhead Compressive strength @ 28 days Tensile strength @ 28 days Flexural strength @ 28 days Density Min / max application temperature Packaging Water addition per pack Yield per pack Coverage per pack Preparation The substrate to which the RonaBond Re-Profiling Mortar is being applied must be structurally sound, stable and suitable to receive and support the mortar. Surfaces should be thoroughly cleaned to remove oil and other contamination. Concrete Repair and Coatings Continued on following page... Other Ranges—Resin Bound and Bonded Surfacing, Screeds, Flooring and Bedding, and Waterproofing and Tanking

RonaBond Re-Profiling Mortar Pre-packed polymer modified mortar for re-profiling vertical and overhead surfaces The substrate should grit blasted, lightly scabbled or similar to expose fine aggregate, thus providing a mechanical key. Damping The prepared surface must be thoroughly dampened with clean water. All surplus water must be removed before the primer is applied. Priming Mix Ronacrete Standard Primer with a slow speed drill and spiral paddle attachment and apply evenly to the damp surface immediately before applying the mixed RonaBond Re-Profiling Mortar. Only prime an area which can...

RonaBond Re-Profiling Mortar Pre-packed polymer modified mortar for re-profiling vertical and overhead surfaces Shelf Life and Storage RonaBond Re-Profiling Mortar should be stored unopened between 5° and 25° C C in dry warehouse conditions and out of direct sunlight. In these conditions shelf life is approximately 6 months. Contains Portland cement. The use of protective clothing, goggles, face mask, overalls, barrier cream and gloves is recommended to prevent any effect from prolonged skin contact, inhalation or ingestion. In the event of skin contact, wash with soap and water. Seek...

RonaBond Re-Profiling Mortar Pre-packed polymer modified mortar for re-profiling vertical and overhead surfaces 0836 Ronacrete Ltd, Flex Meadow, Harlow Essex, CM19 5TD, UK 13 0836-CPR-13/F046 BS EN 1504-3 Concrete Repair Product: RonaBond Re-Profiling Mortar Compressive Strength: > 25 MPa Chloride ion Content: < 0.05% Bond Strength Test: > 0.8 MPa Rest. Shrinkage/Expansion: > 0.8 MPa Reaction to Fire: A2-s1,d0 Dangerous Substances: Refer to Safety Data Sheet The information detailed in this leaflet is liable to modification from time to time in the light of experience and of normal product...