RonaBond FC for Prison Cells Polymer modified, pre-packed fairing coat ■ Pre-packed fairing coat for surface levelling ■ Covers minor blemishes ■ Smooth finish on walls and soffits ■ Provides a 'harder than plaster' finish ■ Easy to apply by trowel or brush ■ Improves carbonation resistance ■ Set time of less than an hour RonaBond FC for Prison Cells is a pre-packed fairing coat mortar which is applied as a skim coat in thicknesses up to 3mm to provide a smooth, hard finish to damaged, blemished and repaired concrete surfaces. RonaBond FC for Prison Cells is used as a levelling mortar prior to the application of protective coatings and paints. It can also be used to give a "harder than plaster" finish to walls in, for example, prisons and detention centres. The material is supplied in preblended form which can be mixed by hand or machine in small lots. Application is by trowel or brush. The surface should be sponge or tight trowelled for a smooth finish before dry. It is recommended that for aesthetics reasons only RonaBond FC for Prison Cells is covered with a protective and/or decorative coating such as RonaBond Joltec or RonaBond Zolpacryl. Test Data Water Permeability Oxygen Diffusion RonaBond FC for Prison Cells 2 x 10"4 Note that all quoted data is based on laboratory tests conducted at 20°C. Cubes, Concrete Repair and Coatings Continued on following page... Other Ranges—Resin Bound and Bonded Surfacing, Screeds, Flooring and Bedding, and Waterproofing and Tanking

RonaBond FC for Prison Cells Polymer modified, pre-packed fairing coat Test Data (continued) tested at 28 days, are 100mm and air cured. Results shown are MAXIMUM laboratory strengths achieved by casting and curing cubes in ideal working conditions; site strengths will be lower. Pack Size Packs required per m³ Yield per pack Coverage per pack Min / max application depth Preparation Ensure that the surface of the concrete is clean and free from loose or friable materials. High pressure water jetting or shot blasting should be carried out to remove residues of old coatings or to key smooth surfaces....

RonaBond FC for Prison Cells Polymer modified, pre-packed fairing coat Shelf Life and Storage RonaBond FC for Prison Cells should be stored unopened between 5°C and 25°C in dry warehouse conditions and out of direct sunlight. In these conditions shelf life is approximately 9 months. RonaBond FC for Prison Cells is non-hazardous although protective clothing such as goggles, overalls and gloves is recommended to prevent any effect from prolonged skin contact, inhalation or ingestion. In the event of skin contact, wash with soap and water. Seek medical advice if irritation or pain occurs. In the...

RonaBond FC for Prison Cells Polymer modified, pre-packed fairing coat 0836 Ronacrete Ltd, Flex Meadow, Harlow Essex, CM19 5TD, UK 13 0836-CPR-13/F045 BS EN 1504-2 Concrete Repair Surface Protection System Product: RonaBond FC for Prison Cells Capillary abs. & perm. to water: W < 0.1kg/m2 .h0.5 Reaction to Fire: Euroclass F Dangerous Substances: Refer to Safety Data Sheet The information detailed in this leaflet is liable to modification from time to time in the light of experience and of normal product application, and before using, customers are advised to check with Ronacrete Ltd, quoting...