3.6. MULTI WALKWAY
8Pages

{{requestButtons}}

Catalog excerpts

3.6. MULTI WALKWAY - 1

3.6. MULTI WALKWAY and accessories

Open the catalog to page 1
3.6. MULTI WALKWAY - 2

MULTI WALKWAY AND ACCESSORIES GENERAL INFORMATION Your benefits at a glance: G Cross over safely from an embankment to a building, from a building to a crane or from one floor to another above an inner courtyard Rapid assembly; safe and rapid implementation Very anti-slip floor surface made from galvanised steel is also very resistant to contamination Good stability thanks to the two side protection frames, which act structurally as truss girders Permissible payload 1.5 kN/m2 with an unsupported span width of 9 m Can also be utilised as an escape route with a greater 2 kN/m2 payload and 6 m...

Open the catalog to page 2
3.6. MULTI WALKWAY - 3

MULTI WALKWAY AND ACCESSORIES GENERAL INFORMATION Of course there are also safe solutions with side protection on sites. These have to be mounted with lots of effort and the admissible load is being determined instinctively and not by static proof. The MULTI walkway guarantees a safe crossing for staff and materials. All parts of the walkway are statical proved for the imposed loads. The moving of the walkway in one piece saves a lot of time and is more safe than the mounting and dismounting of single parts. Extra safe: The side protection height of 1.20 m gives a safe feeling in bigger...

Open the catalog to page 3
3.6. MULTI WALKWAY - 4

MULTI WALKWAY AND ACCESSORIES MOUNTING MULTI walkway: mounting with system – quick and easy ready to use The MULTI walkway will be delivered with included mounted side protection and also on request with mounted pivoting cover plates. Both side protection rails will be folded out one after each other and fixed in a vertical position with two safety bolts. After that the pivoting cover plates will be folded out and the MULTI walkway is ready to use! The coupling of several elements is possible even as quick and easy: 4 cross bolts per joint have to be installed at the coupling lashes of the...

Open the catalog to page 4
3.6. MULTI WALKWAY - 5

MULTI WALKWAY AND ACCESSORIES OPERATIONAL POSSIBILITY AS PASSAGE OR ESCAPE PATH It is possible to couple any number of elements each at a length of 3.00 m one after each other. For the normal use as a walkway 3 coupled elements can cover a length of approx. 9.00 m without support. The admissible area load in this case is 1.5 kN/m², calculated with a length of 9.00 m this results in a total load of approx. 16 kN (approx. 1.6 to). For the use as an escape path a higher area load of 2.0 kN/m² is possible. In this case a length of approx. 6.00 m can be covered without support. Additionally the...

Open the catalog to page 5
3.6. MULTI WALKWAY - 6

MULTI WALKWAY AND ACCESSORIES GENERAL INFORMATION TECHNICAL DATA: MULTI walkway Sizes L x W x D [mm] Weight [kg/unit] * remark: The pivoting cover plates as slopes have to be ordered separately if required MULTI walkway and accessories

Open the catalog to page 6
3.6. MULTI WALKWAY - 7

MULTI WALKWAY AND ACCESSORIES GENERAL INFORMATION TECHNICAL DATA: Pivoting cover plate as a slope for walkway, galvanized Weight [kg/unit] complete with fixing bolts Diagonal struts for MULTI walkway, galvanized Weight [kg/unit] complete with fixing bolts 1 set connecting bolts for the coupling of 2 MULTI walkways 1 set consisting of: Products subject to technical changes

Open the catalog to page 7
3.6. MULTI WALKWAY - 8

Berlin office: Date of issue: January 2020

Open the catalog to page 8

All ROBUSTA-GAUKEL GmbH & Co. KG catalogs and technical brochures