Revo
34Pages

{{requestButtons}}

Catalog excerpts

Revo - 1

- 1 - REVO Instruction Manual

Open the catalog to page 1
Revo - 3

- 3 - DIMENSIONS Fresh air connection Flue blower

Open the catalog to page 3
Revo - 4

- 4 - SPARE PART OVERVIEW

Open the catalog to page 4
Revo - 5

- 5 - SPARE PART OVERVIEW Pos Benennung Artikelnummer 1 Pressing bracket L01441 2 Ash drawer L01447 3 Control panel B15621 Container rear cast grey Z34176 4 Container rear black Z34193 Container cover cast grey Z34194 5 Container cover black Z34195 Shield bottom grey metallic Z34141 6 Shield bottom black Z34196 7 Flat sealing cord 8x2 self-adhesive 103693 Cover strip cast grey Z34197 8 Cover strip black Z34198 9 Double spherical catch 110461 10 Grommet 111730 Front cover grey metallic Z34135 11 Front cover black Z33788 12 Front door Z34084 Front door complete B16324 13 Front door glass...

Open the catalog to page 5
Revo - 8

- 8 - E N G L I S H TECHNICAL DATA (Figure page 3) TECHNICAL DATA Dimensions (mm) and weights (kg) Height [mm] 1038 Width [mm] 520 Depth of the corpus [mm] 606 Weight excluding casing [kg] 149 Weight with stone casing [kg] 237 Flue pipe outlet diameter [mm] 100 Fresh air connection diameter [mm] 50 Heat output range [kW] 2,4 - 9 Room heating capacity depending on house insulation [m³]] 50 – 240 Fuel consumption [kg/h] bis 2,2 Pellet container capacity [kg] 40 Mains connection [V]; [Hz] 230V/50Hz Average electrical power consumption [W] < 100 Protection [A] 1,6 T Efficiency [%] 91,1 CO2...

Open the catalog to page 8
Revo - 9

- 9 - E N G L I S H 1. IMPORTANT INFORMATION GENERAL WARNING AND SAFETY INFORMATION Observance of the introductory general warning information is imperative . Read the entire manual thoroughly prior to putting the stove into operation. . Only approved transport equipment with sufficient load carrying capacity may be used with your heating appliance. . The burning of fuel releases heat energy that leads to extensive heating of the stove surfaces, doors, door and operating handles, glass, flue pipes and possibly the front wall. Refrain from touching these parts without appropriate protective...

Open the catalog to page 9
Revo - 10

- 10 - E N G L I S H 2. WHAT ARE PELLETS? Pellets are made from wood waste from sawmills and planning mills as well as from windfall / thinning. This starting product is shredded, dried and pressed to form fuel pellets without any binders. SPECIFICATIONS FOR HIGH-QUALITY PELLETS: This specification does not conform to ÖNORM M 7135 (ash content 0.5% density) Please request tested fuel and a list of monitored fuel manufacturers from your pellet stove dealer. Use of poor quality or non-approved pellet fuel impairs the function of your stove and may lead to lapsing of the warranty, guarantee...

Open the catalog to page 10
Revo - 11

- 11 - E N G L I S H 3. TECHNOLOGY The technological advances in your new pellet stove are the result of years of testing and practical experience. The practical advantages of your pellet stove are convincing: EASY OPERATION AND OPERATIONAL SAFETY Electronic monitoring and combustion temperature monitoring regulate and control the interaction of flue gas blower, screw conveyor and combustion chamber temperature. This monitoring system ensures optimum combustion and operation status. Your operating input is thus reduced to a minimum – this prevents operating errors with optimum operation....

Open the catalog to page 11
Revo - 12

- 12 - E N G L I S H 5. INSTALLATION OF THE STOVE GENERAL INFORMATION . The unit must be connected to a chimney approved for solid fuels. The chimney must have a diameter of at least 120 mm. . The smoke extraction system is based on negative pressure in the combustion chamber and a slight excess pressure in the flue gas outlet. Therefore it is important that the flue connection is installed correctly and airtight. Only use heat-resistant sealing materials as well as corresponding sealing strips, heat-resistant silicon and rock wool. Assembly may only be performed by authorised specialist...

Open the catalog to page 12
Revo - 13

- 13 - E N G L I S H COMBUSTION AIR Every combustion process requires oxygen or air. This combustion air is taken from the living space without an external combustion air connection for single stoves. This air removed must be replaced in the living space. Very tightly sealed windows and doors in modern flats may mean that too little air replaces that used. The situation also becomes problematical due to additional venting in flats (e.g. in the kitchen or WC). If you cannot feed in external combustion air, then air the room several times a day to prevent negative pressure in the room or poor...

Open the catalog to page 13
Revo - 14

- 14 - E N G L I S H 7. OPERATION BASIC INFORMATION The unit may only be put into operation when assembled completely! Your pellet stove is only approved for the burning of wood pellets of tested quality. The burning of nonpelleted solid fuels (straw, maize, woodchips etc.) is not permitted! Non-observance of these regulations makes void all warranty and guarantee claims and may impair the safety of the unit! Your pellet stove cannot overheat if operated correctly. However incorrect operation may shorten the service life of the electrical components (blower, motors and control system) and...

Open the catalog to page 14
Revo - 15

- 15 - E N G L I S H SIMPLE HEATING OPERATION – EASY MODE – THE FIRST STEPS Your stove is in simple heating mode EASY OFF when delivered in order to ease your start in the world of RIKA pellet stoves. The heat output of the stove can only be increased or reduced in 5 % increments in this mode. As soon as the stove is connected to the socket, the standard display EASY OFF appears. EASY OFF – INACTIVE STATE Key Display Description EASY OFF Standard display for stove switched off in simple heating mode. The output can also be regulated between 30% and 100% with the stove switched off (EASY 30...

Open the catalog to page 15
Revo - 16

- 16 - E N G L I S H EXTENDED HEATING OPERATION – HEAT MODE – COMFORT FUNCTIONS In addition to the basic functions of simple heating operation, the RIKA pellet stove provides extra comfort functions. However, before you can use the comfort functions such as frost protection, installation of an external room thermostat, regulation of the stove mobile telephone, child safety device, you have to change from simple hating to comfort mode. Comfort functions + Change heat output by pressing the + or – key (change in 5 % increments). Display panel Display of respective operating status Switch...

Open the catalog to page 16

All Rika catalogs and technical brochures

Archived catalogs

  1. x cook

    21 Pages

  2. visio

    33 Pages

  3. topo

    36 Pages

  4. rio

    33 Pages

  5. Memo

    36 Pages

  6. Integra II

    32 Pages

  7. Como

    36 Pages

  8. Twist

    20 Pages

  9. tara

    24 Pages

  10. Scena

    19 Pages

  11. Jazz

    20 Pages

  12. Eco Plus

    20 Pages

  13. Eco

    20 Pages

  14. Cult Plus

    20 Pages

  15. Cult

    20 Pages

  16. Alpha II

    19 Pages