Integra II
32Pages

{{requestButtons}}

Catalog excerpts

Integra II - 1

- 1 - Instruction Manual INTEGRA II

Open the catalog to page 1
Integra II - 5

- 5 - CONTENTS Technical specification and spare parts overview 7 1. IMPORTANT INFORMATION 8 2. WHAT ARE PELLETS? 8 Specification for high-quality pellets 8 Pellet storage 8 3. TECHNOLOGY 9 4. AUTOMATIC SAFETY FUNCTIONS Power failure 9 Overheating 9 Low temperature switch off 9 Electrical excess current switch off 9 5. INSTALLING THE STOVE General information 10 Making the chimney connection 10 Method 10 Floor protection 10 Safety distances 11 Electrical connection 11 Combustion air 11 Feed of external combustion air 11 6. FITTING THE PANELLING, OPTIONS General 12 Side panel 12 Control and...

Open the catalog to page 5
Integra II - 6

- 6 - 10. CLEANING AND MAINTENANCE Basic Information 21 Cleaning the fire tray 21 Cleaning the grate door glass 22 Cleaning the flue gas channels 22 Cleaning exhaust gas collector 22 Cleaning exhaust gas fan housing 23 Cleaning pellet container 23 Inspecting door seal 23 Checking chimney connection 23 Cleaning air sensor 23 11. FAULTS – CAUSES - SOLUTIONS Error messages control 24 12. ATTACHMENT Navigation to programme the internal control system 26 13. LIST OF HEADINGS AND ABBREVIATIONS 27 14. WARRANTY We guarantee 29 Warranty card 32 Subject to technical and visual changes; setting and...

Open the catalog to page 6
Integra II - 7

- 7 - E N G L I S H TECHNICAL SPECIFICATION (Fig. 1) TECHNICAL DATA Height [mm] 950 Width [mm] 724 Depth of the corpus [mm] 652 Weight without casing [kg] 155 Flue pipe outlet diameter [mm] 100 Heat output range [kW] 2,5 - 9 Room heating capacity (m3) depending on house insulation [m3] 50 - 240 Fuel consumption [kg/h] 0,7 – 2,2 Pellet container capacity [kg] 62 Mains connection [V]; [Hz] 230/50 Average electrical power consumption [W] < 100 Protection [A] 1.6 T Efficiency [%] 85,7 CO2 content [%] 8,8 CO emission rel. 13% O [mg/Nm3] 136 Dust emissions [mg/Nm3] 22 Exhaust mass flow [g/s] 9,2...

Open the catalog to page 7
Integra II - 8

- 8 - E N G L I S H 1. IMPORTANT INFORMATION GENERAL WARNING AND SAFETY INSTRUCTIONS The general introductory warning information must be followed. œ Read the whole of the manual thoroughly before commissioning the stove. œ Only approved transport aids with adequate load bearing capacity must be used for transporting your stove. œ Your stove is not suitable for use as a ladder or scaffold. œ The burning of fuel releases heat energy that leads to extensive heating of the stove surfaces, doors, door and operating handles, glass, flue pipes and possibly the front wall. Refrain from touching...

Open the catalog to page 8
Integra II - 9

- 9 - E N G L I S H 2. WHAT ARE PELLETS? Pellets are made from wood waste from sawmills and planning mills as well as from windfall / thinning. This starting product is shredded, dried and pressed to form fuel pellets without any binders. SPECIFICATIONS FOR HIGH-QUALITY PELLETS: This specification does not conform to ÖNORM M 7135 (ash content 0.5% density) Please request tested fuel and a list of monitored fuel manufacturers from your pellet stove dealer. Use of poor quality or non-approved pellet fuel impairs the function of your stove and may lead to lapsing of the warranty, guarantee and...

Open the catalog to page 9
Integra II - 10

- 10 - E N G L I S H 3. TECHNOLOGY Your new pellet stove is technologically advanced as a result of years of tests in the laboratory and in practice. The practical advantages of your pellet stove are convincing: OPERATING COMFORT – OPERATIONAL RELIABILITY The electronic monitoring device together with a patented “air sensor” controls and regulates the interplay of flue gas fan, conveyor auger, convection fan and temperature. This monitoring system guarantees an optimum combustion and operating mode. Your operating outlay is reduced to the most necessary - this prevents operating faults...

Open the catalog to page 10
Integra II - 11

- 11 - E N G L I S H 5. INSTALLING THE STOVE GENERAL INFORMATION The stove must be connected to a chimney that is approved for solid fuels. The chimney must have a diameter of at least 120 mm. The flue system is based on negative pressure in the combustion chamber and a slight overpressure on the flue gas outlet. It is therefore important that the flue gas connection is fitted correctly and is airtight. Only use heat resistant sealing materials, as well as the relevant sealing bands, heat resistant silicon and mineral wool. Only authorised technical personnel must carry out assembly work....

Open the catalog to page 11
Integra II - 12

- 12 - E N G L I S H ELECTRICAL CONNECTION The stove is supplied with an approx. 2.5 m long connecting cable with a plug. The cable must be connected to a 230 V, 50 Hz electrical supply. The average electric power consumption is approx 100 watts during heating. During the automatic ignition process (duration 10 minutes) approx. 350 watts. The connection cable must be laid so that any contact with hot or sharpedged external surfaces on the stove is avoided. COMBUSTION AIR Each combustion procedure requires oxygen or air. As a rule this combustion air is removed from the living area for...

Open the catalog to page 12
Integra II - 13

- 13 - E N G L I S H 6. ASSEMBLY OF PANELS, OPTIONS GENERAL CAUTION! Only work on the unit when the mains plug has been disconnected. Your stove must be switched off and cooled before any work is performed. Do not allow objects (screws etc.) to fall into the fuel container – they can block the screw conveyor and damage the stove. SIDE PANEL 1. Insert the side sections in the receiving seat provided on the bottom section. 2. Push the side section against the stove until it is vertical. 3. Then fasten with two screws in the pellet container Repeat on the other side of the stove. CONTROL AND...

Open the catalog to page 13
Integra II - 14

- 14 - E N G L I S H 7. OPERATION BASIC INFORMATION The stove must only be started when fully fitted. Your pellet stove is exclusively for burning pellets made from wood of a controlled quality. Non-pelletised solid fuels (straw, maize, chopped matter etc.) are not permitted. Failure to adhere to these guidelines will make all guarantee and warranty claims null and void and could have a negative effect on the safety of your stove. When operated correctly your pellet stove cannot overheat. Improper operation can however shorten the life expectancy of the electric stove components (fan,...

Open the catalog to page 14

All Rika catalogs and technical brochures

Archived catalogs

  1. x cook

    21 Pages

  2. visio

    33 Pages

  3. topo

    36 Pages

  4. rio

    33 Pages

  5. Revo

    34 Pages

  6. Memo

    36 Pages

  7. Como

    36 Pages

  8. Twist

    20 Pages

  9. tara

    24 Pages

  10. Scena

    19 Pages

  11. Jazz

    20 Pages

  12. Eco Plus

    20 Pages

  13. Eco

    20 Pages

  14. Cult Plus

    20 Pages

  15. Cult

    20 Pages

  16. Alpha II

    19 Pages