DATA SHEET formparts formparts.mono formparts.mono are made from a single panel using folding moulds. This results in the characteristic radius. formparts.fab are made from flat panels with mitre cut which are later joined in different angles. This method allows forming comparably crisp edges. A different colour, surface and texture can be selected for each side. Radius Standard: 3 - 15 mm Radius Optional: 3 - 9 mm (S) | 9 - 15 mm (M) | > 15 mm (L) Surfaces: ferro, ferro light; solo (only Interior) B: max. 1500 mm (depending on radius) Radius: min. 200 mm max. 180˚ Length: max. 3800 mm ferro, ferro light, matt; solo (only interior) Special shape S: max. 600 mm Sum S: max. 1500 mm, max. 4 angles Angle: on request Length: max. 4500 mm S: 50 - 1500 mm Sum S: max. 2000 mm Angle: on request Length: max. 4500 mm IMPORTANT NOTES • Special lengths, shapes, colours and textures are available on request. • The individual formparts.fab panels must always be connected by means of brackets. These can be provided and installed by Rieder or by the customer but may be required for transport. • formparts.fab and formparts.mono must be fitted with substructures (possibly at the factory already for handling reasons, depending on their size). These can be provided by Rieder as a service or by the customer. Examples of substructures can be sent on request. • Width and length may be swapped on request. More details on www.rieder.cc. • The load transfer to the building by means of a substructure or brackets must be ensured and coordinated for each project. • The position of the fixing points must always be clarified individually for each specific project. • For formparts, a project specific testing may be necessary. • Due to the fragility of the product, when designing the shapes and sizes, careful handling must be taken into c