Catalogs >
Resoltech >
8010 W

8010 W
4Pages

Catalog excerpts

resoltech * resoltech 8010 W Hardener 8015 W Water based sprayable epoxy filler - Models/patterns making - Direct moulds - Room temperature curing - 1.7mm thick max by layer - Very easy to sand - No COV and CMR component - Polystyrene compatible

Open the catalog to page 1

RESOLTECH 8010 W / 8015 W system results of the latest advances in epoxy chemistry formulation and eliminates all solvents used normally with sprayable primers and fillers, replacing them with water, thus improving the H&S conditions for workers. 8010 W enables to produce models or direct moulds on any type of support previously milled by CNC or by hand. This filler can be applied on all supports, composite, wood, foam, calibrated wax, polystyrene. It is recommended to apply a layer of 1010 ECO / 1014 on porous substrate as wood, this limit water absorption of this and avoid crack of 8010 W...

Open the catalog to page 2

8015 W : Yellow viscous liquid Mix : Light grey viscous liquid Visual aspect I 8010 W : Light grey paste * on polystyrene substrate Drying time may vary depending on dilution ratio with water.

Open the catalog to page 3

RESOLTECH 8010 W / 8015 W system cures at room temperature. Like for all water based products, curing time will depend on the local conditions: well ventilated / dry conditions will favour the cure speed. Tg measured by DSC, 10°C/min, inflexion point Shore A hardness measured at 23°C according to ISO 868 HEALTH & SAFETY PACKAGING - Plastic pot of 0.5kg + 0.105kg - Plastic bucket of 3kg + 0.63kg - Plastic bucket of 10kg + 2.1kg - Plastic bucket of 15kg + 3.15kg TRANSPORT & STORAGE Keep containers sealed and away from heat and cold preferably between 10°C and 30°C in a well ventilated area....

Open the catalog to page 4

8010 W 4Pages

Catalog excerpts

All Resoltech catalogs and technical brochures

8010 W
4Pages