1050 ECO
5Pages

Biobased Structural Laminating Epoxy System - 36% biobased on resin part* - Adjustable pot life from 13mn to 13h13mn - Room temperature cure & mould release - Excellent wetting properties on all reinforcements - For small to XXL size parts productions *ratio of the number of biobased carbon atoms / the number of total carbon atoms Datasheet V3 - 28.03.2023 / Version précédente - 14.09.2022

The 1050 ECO epoxy laminating system is formulated to manufacture high performance lightweight structures with glass, carbon, aramid, basalt and natural reinforcements with or without post-curing. This latest generation system, without CMR substances (including salicylic acid) according to GHS criteria is optimized with a low exotherm, low viscosity and excellent air release properties. This epoxy system is also suitable for the manufacture of small to very large structures and composite parts by wet lay-up, infusion, injection moulding or filament winding while guaranteeing low toxicity...

* Gel time measurements realized with Rheotech® ** Gel time on film measurement realized on rheometer Indication on the choice of hardener according to ambient temperature conditions : • For the whole year, the use of 1056S hardener is recommended ; • For winter conditions, the use of 1058S is recommended ; • For summer conditions, the use of 1055S hardener is recommended. Datasheet V3 - 28.03.2023 / Version precedente - 14.09.2022

In order to obtain the maximum thermo-mechanical properties, it is necessary to respect the recommended curing cycle. The table below shows the glass transition temperatures (DSC) according to different curing cycles. Flexion properties on pure resin according to ISO 178 Datasheet V3 - 28.03.2023 / Version precedente - 14.09.2022

HEALTH & SAFETY - Pastic jerrycan kit of 1kg + 0.35kg - Pastic jerrycan kit of 5kg + 1.75kg - Pastic jerrycan kit of 28kg + 9.8kg - Drum kit of 200kg + 3 x 23,33kg - IBC kit of 1t + 2 drums of 175kg TRANSPORT & STORAGE Keep containers sealed and away from heat and cold preferably between 10°C and 30°C in a well ventilated area. Our products are guaranteed in their original packaging (check expiry date on the label). Skin contact must be avoided by wearing protective nitrile gloves & overalls or other protective clothing. Eye protection should be worn to avoid risk of resin, hardener,...