RAIS Q-BIC & RAIS Q-BIC INSERT
40Pages

ENGLISH RAIS - manual for Q-BIC & Q-BIC insert 1 USER MANUAL RAIS Q-BIC & RAIS Q-BIC INSERT

We cannot be held responsible for any misprints.

ENGLISH RAIS - manual for Q-BIC & Q-BIC insert 4 Introduction Thank you for purchasing a RAIS wood burning stove. These appliances have been approved by HETAS Ltd as intermittent operating appliances for burning wood logs only. A RAIS wood burning stove is more than just a heat source: it also shows that you care about design and quality in your home. To make the most of your wood burning stove it is important that you read the manual thoroughly, before installing and using it. In the case of warranty coverage, and for general queries regarding your wood burning stove, it is important that...

ENGLISH RAIS - manual for Q-BIC & Q-BIC insert 5 RAIS Q-BIC 106 RAIS Q-BIC 127 RAIS Q-BIC insert Nominal output (kW): 4,5 4,5 4,5 Min./Max. output(kW): 2-6 2-6 2-6 Heating area (m2) ca. 80 ca. 80 ca. 80 Stove’s width/depth/height (mm) 404-404-1060 404-404-1270 426-418-850 Combustion chamber’s width/depth/height (mm) 288-288-500 288-288-500 288-288-500 Recommended amount of wood when fuelling (kg): (Distributed on 2-3 logs of wood of approx. 25 cm) 1,6 1,6 1,6 Min. uptake (Pascal): -12 -12 -12 Weight (kg): 143 153 140 Smoke gas mass flow (g/s): 6,3 6,3 6,3 Smoke gas temperature (°C): with...

ENGLISH RAIS - manual for Q-BIC & Q-BIC insert 6 Convection RAIS stoves are convection stoves. This means that the stove’s back and side panels are not over-heated. Convection means that there is a circulation of air, which ensures that the heat is distributed more evenly throughout the entire room. The cold air is sucked in at the base of the stove up through the convection channel, which runs along the stove’s combustion chamber. The heated air pours out at the top of the stove, which ensures a circulation of warm air throughout the room. The stoves are equipped with a “cold” lever – RAIS...

ENGLISH RAIS - manual for Q-BIC & Q-BIC insert 7 Installation instructions The following pages give instructions for the safe and proper installation of this heating appliance in the UK. These instructions cover the basic principles of installation, although detail may need slight modification to suit particular local site conditions. In all cases the installation must comply with current UK Building Regulations, Local Authority Byelaws and other specifications or regulations as they affect the installation of the stove. Please note that it is a legal requirement under England and Wales...

ENGLISH RAIS - manual for Q-BIC & Q-BIC insert 8 Chimney The chimney is the driving force which makes the stove function. In order for the stove to perform satisfactorily the chimney height must be sufficient to ensure the correct draught of 14 to 18 Pa so as to clear the products of combustion and prevent problems of smoke emanating into the room when firing. NOTE: A chimney height of not less than 4.5 metres measured vertically from the outlet of the stove to the top of the chimney should be satisfactory. Alternatively the calculation procedure given in BS 5854:1980 may be used as the...

ENGLISH RAIS - manual for Q-BIC & Q-BIC insert 9 If it is found that there is excessive draught in the chimney then either an adjustable flue damper or alternatively a draught stabiliser should be fitted. The adjustable flue damper should not close off the flue entirely but should in its closed position leave a minimum continuous opening free area of at least 20 % of the total cross sectional area of the flue or fluepipe. Adequate provision e.g. easily accessible soot door or doors must be provided for sweeping the chimney and connecting fluepipe. You should also familiarise yourself with...

ENGLISH RAIS - manual for Q-BIC & Q-BIC insert 10 Manufacturer’s Plate for Q-BIC ƒOƒPƒPƒPƒQƒRƒPƒPƒP ƒOƒPƒSƒU ƒOƒPƒSƒOƒT ƒOƒRƒPƒQƒVƒPƒP ƒOƒPƒSƒT ƒOƒPƒQƒRƒPƒW ƒOƒPƒSƒU ƒOƒPƒQƒUƒPƒW ƒOƒPƒQƒTƒP ƒUƒPƒQƒOƒRƒP ƒOƒPƒSƒX ƒYƒZƒ[ƒY ƒ\ƒ]ƒ^ƒ^ƒZƒ_ƒ\ƒ`ƒaƒZƒbƒ[ƒ]ƒcƒ`ƒ^ƒdƒ`ƒeƒaƒbƒfƒeƒaƒ^ƒ]ƒYƒ]ƒ`ƒgƒeƒ`ƒaƒhƒiƒ^ ƒOƒOƒSƒR ƒOƒPƒQƒTƒW ƒjƒaƒVƒPƒP ƒVƒPƒPƒQƒOƒPƒPƒP ƒOƒPƒSƒk ƒOƒPƒQƒOƒPƒW ƒOƒRƒPƒQƒVƒPƒP ƒZƒbƒ[ƒ]ƒcƒ`ƒ^ƒdƒ`ƒaƒ]ƒaƒhƒh ƒ\ƒ]ƒ^ƒ^ƒZƒ_ƒ\ƒ`ƒaƒZƒbƒ[ƒ]ƒcƒ`ƒ^ƒdƒ`ƒeƒaƒbƒfƒeƒaƒ[ƒ]ƒYƒlƒ`ƒ^ƒhƒiƒ^ ƒOƒPƒSƒm ƒTƒPƒQƒOƒRƒP ƒUƒQƒX ƒOƒPƒSƒO ƒPƒSƒTƒQƒU ƒ[ƒ]ƒYƒlƒ`ƒ^ƒZƒbƒ[ƒ]ƒcƒ`ƒ^ƒdƒ` ƒlƒfƒeƒ\ƒ`ƒdƒ\ƒ`ƒaƒdƒ]ƒ_ƒ` ƒOƒPƒSƒO...

ENGLISH RAIS - manual for Q-BIC & Q-BIC insert 11

ENGLISH RAIS - manual for Q-BIC & Q-BIC insert 12 Installation instructions - Q-BIC insert First loosen the screw in upper right corner and the screw in lower left corner (both door side) - do not onscrew entirely - now it’s possible to remove the insert from the cassette. Prefaration of cassette Disassemble the two screws keeping the stiffening rib in position. By a panelled wall: Assemble the cassette, the upper covering plate and the stiffening rib with the two screws.